|
1 Attachment(s)
Only "full" pic I have ..
[ATTACH=CONFIG]563615[/ATTACH] |
this go at it may i suggest 8620 cam cores!
|
Originally Posted by Full Force
(Post 4518331)
They uploaded wrong basically just showing another set of cams, not bob specs, not cam motion... and same type of wear... at this point I'm buying new cams and all grinds are very close so if the grind was my issues then I will be good to go.
|
hey trying to getterdone,did i spell that correctly?lol.
|
I think Tim should start a new thread on oso and FB, apologizing to Bob Maderi , and letting all the guys who had a few hundred sleepless nights over cam lobe wear issues, that
ITS FINE. Kip Farberware said its normal wear. Carry on! |
Originally Posted by MILD THUNDER
(Post 4518338)
Tim, you run pure kerosone for engine oil?
|
Wait a second ...hold on. I put my machinist bi-focals on, and called over my neighbors Golden Retriever, who moonlights as a seeing eye dog. He's been grinding camshafts since the smokey yunick days. I had him take a look on my 80 inch 4k machinist AERA approved monitor, and yep. Its confirmed. Its definitely crap.
https://www.youtube.com/watch?v=kILUH34MJsU
|
Originally Posted by MILD THUNDER
(Post 4518338)
Tim, you run pure kerosone for engine oil?
|
Diet Dr Pepper , even when evaporated into air, will etch even the strongest of metals.
|
I'm glad it's all fun and games when I'm over here spending thousands and thousands and pulling my hair out ....
|
| All times are GMT -5. The time now is 11:22 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.