|
Is this engine ran in saltwater?
|
Originally Posted by adk61
(Post 4526119)
I also have an oval port head available :eekdrop:
|
Originally Posted by phragle
(Post 4525992)
there are 1,352,751 threads on building 454s on this site.
But you need to tell us what specifically you want to accomplish and your budget.... You could easily build a 420 clone, a 420 clone with better heads... Do you want to go with a roller cam? Do you want to spin 5000 rpm or 6200 rpm? a basic vanilla build of a stock 454 mag bottom with budget friendly EQ heads, or a little more for Big Al's heads or a lot more for some AFRs, something somewhere between a 731/ 741/500 efi roller cam setup and valvetrain, a set of used sm's or gills could get you in the neighborhood of 450-500 hp easily but each setup would be a little different. |
Sutphen 30
306 CC intake runner, 2.25 SS Ferrea Intake valves, 1.900 Super Alloy Ferrea exhaust valves, Pac springs (spec'd to customer cam) hardened steel !0* locks and retainers, ARP studs and hardened 3/8" guideplates... All my heads are spec built, not production line off the shelf product (more bang for your buck) takes a bit longer to get a lot more, but worth the painfree process |
Originally Posted by adk61
(Post 4526162)
Sutphen 30
306 CC intake runner, 2.25 SS Ferrea Intake valves, 1.900 Super Alloy Ferrea exhaust valves, Pac springs (spec'd to customer cam) hardened steel !0* locks and retainers, ARP studs and hardened 3/8" guideplates... All my heads are spec built, not production line off the shelf product (more bang for your buck) takes a bit longer to get a lot more, but worth the painfree process That's the oval port. I was thinking they were 290 cc. Then again I thought the smaller rectangular ports were 320 but they are 317. Regardless what great heads and I hope they really take off. |
290 edelbrock heads (Marine if kept in salt water), Torker II intake (even with just a 315 HP cam is a big jump like adding 75 100 something NOS) Magnum cam even better and go with the newer Magnum firing order. Notch the bores for intake valve clearance. 850 Quick Fuel marine carb. Figure in different props too
|
Originally Posted by getrdunn
(Post 4526166)
That's the oval port. I was thinking they were 290 cc. Then again I thought the smaller rectangular ports were 320 but they are 317. Regardless what great heads and I hope they really take off.
|
salt yes
|
casting 049 large oval port heads. Will make more torque down low, good to 6000rpm if massaged a little. will need to have hardened seat put in for unleaded fuel, and of course, change intakes. Best high torque old school head around, IMHO.
|
A block that age I would make sure to have it mag'd and sonic tested. You may also find yourself needing to helicoil all of the head bolt boss'es. Might be better off buying a 454HO or 502HO long block.
|
| All times are GMT -5. The time now is 02:46 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.