Offshoreonly.com - Input shaft for new style (sloped) Bravo X same as XR or different?

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- General Q & A (https://www.offshoreonly.com/forums/general-q-20/)

- - Input shaft for new style (sloped) Bravo X same as XR or different? (https://www.offshoreonly.com/forums/general-q/348461-input-shaft-new-style-sloped-bravo-x-same-xr-different.html)

HTRDLNCN

07-16-2017 02:22 PM

Input shaft for new style (sloped) Bravo X same as XR or different?

Getting a newer X drive that is missing input shaft and ujoint,,was told its different than standard bravo.. Will xr fit or the X different from that as well.. also can u-joint be replaced? Does it use different gimble bearing or is there an adapter shaft to go from an x/xr drive to a bravo 1 gimble bearing? Thanks!

JaayTeee

07-16-2017 05:23 PM

Just get the X/XR input shaft assy....you'll want the red dot or white dot gimbal bearing

HTRDLNCN

07-17-2017 09:37 AM

dont need the whole assembly,, just the engine/boat side which I found here on swap shop for $180 and the u joint..

All times are GMT -5. The time now is 12:02 PM.