The in house guys are trying to get deep into your pocket, as AD has pointed out looks like this can be fixed with a little work and not much cost

ok do you guys know any part # s or something like that ?

My fault i didn't see the link .. i do now. Ok should i flatten that stuff on the out-drive itself with a file ?

Thank you for the assistance !

yes, while oil fitting is out dress the surface of bellhousing, if its gouged bad from prying (i cant tell from your pics on myphone) you could jb weld and file the surface worst case scenario

Arctic friends, yes i got some Magnatex ..or something like that. I will be looking at it today after work.

Love the knowledge of this board, and the willingness to share.

THANK YOU TO ALL !

I got a Very Nice Used Bell Housing from a friend he is bringing tomarrow.

Ordered the other piece today.

Next time count the nuts in in your hand before prying ....lol...........good luck

You are totally Right