Offshoreonly.com - Dui igntion module 7 pin gm

Page 2 of 2

Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- General Q & A (https://www.offshoreonly.com/forums/general-q-20/)

- - Dui igntion module 7 pin gm (https://www.offshoreonly.com/forums/general-q/355431-dui-igntion-module-7-pin-gm.html)

SB	07-18-2018 11:03 AM

Quote:

Originally Posted by articfriends (Post 4638491)

i used the clear stiff that came w the dui module

Heat transfer paste cannot be clear. They must have sent you dielectric grease like every other goddam ****ing parts supplier. Pisses me off !

payuppsucker

07-18-2018 11:24 AM

^^^^^^^^^^^agreed, the clear stuff is dielectric.

articfriends

07-18-2018 11:37 AM

Quote:

Originally Posted by F-2 Speedy (Post 4638493)

that's a good number............are those 2.3 whipp's

Yes, not done yet either, will post results in my other thread later. Picking up 120+ intake air off headers which skews cf 3 or 4% (shop was 85 or 90), built a inlet duct to pull air farther out and lower intake temps. Repulling and tuning soon

articfriends

07-18-2018 03:02 PM

Was coil, fired it up today, started pulling with stock.module that worked at end of day, breaking up again, does it early sometimes today, isually IF module gets hot and goes haywire its at high rpms. Swapped dui coil on, pulled flawlessly.
fashioned a air duct to get cooler air away from the headers. Been tuning, well past 700 hp w biggest pulley.https://cimg8.ibsrv.net/gimg/www.off...be1c38aa9b.jpg

F-2 Speedy

07-18-2018 03:08 PM

That is some velocity stack my friend......

All times are GMT -5. The time now is 04:21 AM.

Page 2 of 2

Show 40 post(s) from this thread on one page