Offshoreonly.com
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   General Q & A (https://www.offshoreonly.com/forums/general-q-20/)
-   -   Oil & PS coolers (https://www.offshoreonly.com/forums/general-q/355958-oil-ps-coolers.html)

Texascuda 08-15-2018 10:36 AM
Originally Posted by 1BIGJIM (Post 4643825)
Why did you unbolt the motor mounts from engine instead of taking off the one bolt?😎
Motor was aligned trying to keep it somewhat the same place,. didn't have the alignment tool but after reading I bought one so I could have done it but I'm hoping its somewhat still aligned.

Regards,

BenPerfected 08-16-2018 10:38 AM
Originally Posted by Texascuda (Post 4643827)
Motor was aligned trying to keep it somewhat the same place,. didn't have the alignment tool but after reading I bought one so I could have done it but I'm hoping its somewhat still aligned.

Regards,
Somewhat aligned is not good if you plan to run it.

Texascuda 08-16-2018 10:54 AM
Got the bravo alignment tool and will check the alignments understand somewhat is not good enough.

Regards,


All times are GMT -5. The time now is 05:41 AM.
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.