Offshoreonly.com - Trim limit adjustment

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- General Q & A (https://www.offshoreonly.com/forums/general-q-20/)

- - Trim limit adjustment (https://www.offshoreonly.com/forums/general-q/356142-trim-limit-adjustment.html)

Force265

08-19-2018 10:02 AM

Trim limit adjustment

Bravo 1. Am I’m missing something? Drive down and marks aligned then position sending unit on full clockwise. Now do I need someone holding drive button up then tun counterclockwise to desired length? Then lock it down And is it 20 3/4 or 21 3/4

thank you!

BUP	08-19-2018 10:09 AM

Bravo = 21 - 3/4 ram center pin to pin
Alpha gen 1 the same

Alpha gen 2 = 20 - 3/4

All trim adjustments and limit adjustments are in the Bravo service manuals.

Force265

08-19-2018 10:53 AM

So I’m turned completely clockwise and I’m at 24 pin to pin. I can’t turn counterclockwise or it goes higher. I’m pretty sure I aligned marks before placing?

AllDodge

08-19-2018 01:46 PM

Lower the drive, align the marks then raise it till it stops. If its to high, lower the drive some, rotate the switch a little and raise the drive again. If it got worst, lower the drive and rotate the switch the other way, then raise again. Repeat until it meets the spec or is a tad less, just not over

All times are GMT -5. The time now is 10:37 PM.