|
HP 500 hours
Hello, just wondering if there is anyway to tell how many hours are on a carb HP 500? Supposedly the key needed to be on for the radio to work, so it ran the hour meter up, but has since been re-wired. I don’t think there is anyway to tell being that it is not EFI but just wondered. Thanks a lot |
No way to tell hours
|
Originally Posted by Danomac235
(Post 4647146)
Supposedly the key needed to be on for the radio to work, so it ran the hour meter up,
|
Wouldn’t the alarm/warning buzzer be going off the whole time too....? |
with the Merc DDT and or Diacom with the correct adaptors all T bolt V ignition modules can be scanned for hours per rpm ranges.
Again if the engine has a MERC T bolt ign ./ module set up then you can scan for the hours per rpm ranges. NO OTHER SCAN OPTIONS using a scan tool are offered with T bolt V only what I mentioned here.. |
hour meter gauges some are installed not correctly - I seen them were the key position turned left ( counterclock wise ) for battery power to the stereo or whatever will also run the hour meter. Again depends on how it was wired -- by whomever.
with key on only ( one click to the right ) Not all warning horn outputs are a solid continues horn alarm when Key on only (test ) - it does vary between different apps thru the years, Just saying for one of the posts above.. |
| All times are GMT -5. The time now is 07:30 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.