|
Port side drive will not come up to trailer position?
Both drives trim up and down fine, but when I'm ready to take the boat out of the water port side will not come up for trailer mode? what can I check?
|
Bravo drives I assume? Most likely the trim limit switch. Depending if this is a bravo or XR depends exactly where it is but it’ll near where the drive meets the helmet or on the pivots of the gimbal ring.
|
Originally Posted by IGetWet
(Post 4695222)
Bravo drives I assume? Most likely the trim limit switch. Depending if this is a bravo or XR depends exactly where it is but it’ll near where the drive meets the helmet or on the pivots of the gimbal ring.
|
May be a separate relay for trailer switch
|
Originally Posted by GPM
(Post 4695236)
May be a separate relay for trailer switch
|
FWIW, only a handful of builders use that capability. There is no issue with bypassing the trailer limit switch. . |
https://cimg5.ibsrv.net/gimg/www.off...9613e36409.png
Originally Posted by Sydwayz
(Post 4695256)
FWIW, only a handful of builders use that capability. There is no issue with bypassing the trailer limit switch. . |
Do you have HP transom assemblies? |
Originally Posted by JaayTeee
(Post 4695326)
Do you have HP transom assemblies? |
maybe a wire came off of the trailer switch? |
| All times are GMT -5. The time now is 08:25 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.