Supercharger water intecooler feed line
#1
Registered
Thread Starter
Supercharger water intecooler feed line
Where is the best place to connect the water supply line to the supercharger water intercooler? Currently its has a tee fitting on the hose that goes from the outdrive to the seawater pump...
r,
Eric
r,
Eric
#2
Platinum Member
Platinum Member
iTrader: (6)
most run a 2 stage sea pump,
#6
Platinum Member
Platinum Member
Yes they are, the set up is new to me this year. In the process of reassembling, so no actual results. The reason I went with independent pickups instead of 2 stage pump was, at idle a cold inter-cooler can cause fuel to condense.
177 Weiand Blower with Holley Sniper
Sales staff at Teague advised that I shouldn't need pressure blow off valves at the 80++mph top speed I am hoping to get to
-10 pickup and supply with 2 x -8 dumps
177 Weiand Blower with Holley Sniper
Sales staff at Teague advised that I shouldn't need pressure blow off valves at the 80++mph top speed I am hoping to get to
-10 pickup and supply with 2 x -8 dumps
#7
If you live in a hot climate area, you may want to push water through it all of the time so it doesn't detinate after idling for any length of time.
Last edited by GPM; 07-11-2019 at 10:08 PM.
#9
Registered
Multiple ways of doing it but as mentioned above climate and water temps have a lot to do with how you want to plumb it.