Offshoreonly.com
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   General Q & A (https://www.offshoreonly.com/forums/general-q-20/)
-   -   efi wiring (https://www.offshoreonly.com/forums/general-q/367163-efi-wiring.html)

diamondk 07-25-2020 08:24 PM
Originally Posted by SB (Post 4750048)
Most factory Vortec headed motors 30* total timing. Most other sbc’s 32* total timg.

edit: making sure you see the word total :)
soooo that would be at WOT? What should it be set at idle speed or what rpm should i set it at?

Blueabyss 07-26-2020 01:23 PM
10 Degrees

diamondk 07-27-2020 09:24 AM
Originally Posted by Blueabyss (Post 4750099)
10 Degrees
Thank You!

SB 07-27-2020 09:33 AM
Originally Posted by Blueabyss (Post 4750099)
10 Degrees
Sounds like he has a dui (in cap coil hei) distributor. How do you know where his total is ?

SB 07-27-2020 09:38 AM
Originally Posted by diamondk (Post 4750053)
soooo that would be at WOT? What should it be set at idle speed or what rpm should i set it at?
No, not WOT.

You rev engine to where advance stops advancing and check a few hundred rpm higher to make sure advance no longer advances. You’ll need a degreed balancer, timing tape, or adjustable advance timing gun to do this.


All times are GMT -5. The time now is 11:31 PM.
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.