Originally Posted by ICDEDPPL
(Post 4816943)
First that`s going to destroy your outdrive, I don`t care what George says, bravo gears are small and you can`t change that fact.
Secondly, rod angles and whatnot , all that is $hit in stuff over 600ci. I don`t like this plan at all. Sorry, not sorry. |
Originally Posted by KWright
(Post 4816948)
Dan hit the nail right on the head. Personally I wouldn't go any bigger than 565. You can stay with standard deck, rod angles are good and no goofy geometry on parts. I have 565's 9.3 compression efi's that make just a few hp shy of 800 hp. with a real good torque band. And on drives I wouldn't consider anything less than the scx. Already been down that rabbit hole. Any ways that's my 2 cents worth.
Noted. Soaking it all in. Thanks. Brad. (937)545-8991 |
Originally Posted by KWright
(Post 4816948)
Dan hit the nail right on the head. Personally I wouldn't go any bigger than 565. You can stay with standard deck, rod angles are good and no goofy geometry on parts. I have 565's 9.3 compression efi's that make just a few hp shy of 800 hp. with a real good torque band. And on drives I wouldn't consider anything less than the scx. Already been down that rabbit hole. Any ways that's my 2 cents worth.
Are those 10.2” decks or 9.8”? Curious…. Thanks. Brad. (937)545-8991 |
9.8
|
If I`m spending your money
Big M block.
565ci Machine for 55mm cam and .904 lifters.I believe you can buy them from Dart with those options.(so over kill lol) Solid roller. Tunnel ram JE pistons Molnar crank and rods. Belt drive Pro 1 heads. Shaft rockers probably run forever :drink: |
or buy it already built from Shafiroff
Dan,
The breakdown on the short block is as follows. Stage IIRated For Up To 1250 HP
|
I personally would not put that much power in that hull. I don't know how much power someone has put in that hull, but I would not want to be the guinea pig.
|
This is about 90% of what you’re trying to do.
https://cimg6.ibsrv.net/gimg/www.off...ed1c84342.jpeg What you want is very custom, better find a reputable builder. |
Originally Posted by hogie roll
(Post 4816972)
This is about 90% of what you’re trying to do.
https://cimg6.ibsrv.net/gimg/www.off...ed1c84342.jpeg What you want is very custom, better find a reputable builder. |
I like the color of that motor,,looks sinister
|
All times are GMT -5. The time now is 02:09 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.