Power trim toggle switch replacement, what amperage is needed?
 

Hi, My bravo drive has a toggle switch on the wheel, and it's getting sticky and needs to be replaced. And it has to fit in the anodized bracket (looks like a standard size, about 1" long)

The specs are 16 (4) A 250V~t85u 16A 250VAC Non Ind (not sure what the 4 in brackets means?)
And the switch is a C1522WR

This is what came with the boat, installed by DCB, so I assume it is sufficient.

The one I did find that looks the same size, so should fit has these specifications:
ITT CM Seriers
16A 125 VAC 1/8 HP
10A 250VAC 1/3HP

Please let me know.

Thanks!

Very little amps. I’m sure less than 1.The switch just sends low power to the relays on the pump which handle the high amp loads.

Ayuh,..... 'bout any momentary 3 position toggle switch will work,.....

I've added several in different places on the boat, run in parallel with the original,....
The one on the transom is the handyist, can trim/ tilt the drive, without crawlin' into the boat,....