Offshoreonly.com

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   General Q & A (https://www.offshoreonly.com/forums/general-q-20/)
-   -   496 mag strange intermittent problem (https://www.offshoreonly.com/forums/general-q/376111-496-mag-strange-intermittent-problem.html)

bobz71 06-19-2022 03:13 PM

496 mag strange intermittent problem
 
please help if possible 496 mag intermittent problem, while driving the boat starbd motor starts to run crappy , black smoke, lower rpms than other motor, if i shut off motor then the battery and wait a sec it seems to reset something, then engine runs fine, seems like an overfueling problem, stuck injector? idk one thing i noticed was when this condition is happening when you turn the key on fuel pump should prime for a few seconds then shut off , while in this condition it never shuts off. any help is appreciated.

AllDodge 06-19-2022 04:32 PM


Originally Posted by bobz71 (Post 4835850)
please help if possible 496 mag intermittent problem, while driving the boat starbd motor starts to run crappy , black smoke, lower rpms than other motor, if i shut off motor then the battery and wait a sec it seems to reset something, then engine runs fine, seems like an overfueling problem, stuck injector? idk one thing i noticed was when this condition is happening when you turn the key on fuel pump should prime for a few seconds then shut off , while in this condition it never shuts off. any help is appreciated.

Fuel pump doesn't shut off. That is different but when the motor is running the fuel pump will not shut off.
Check fuel pressure and need to scan for codes
Also could use your motor serial number?

bobz71 06-19-2022 05:25 PM

yes i know it doesnt shut off while running , i shouldve specified that not while engine is running but when i turn on key to prime the system before i crank motor the pump will just keep running, seems like something is just causing fuel to dump in and not combust i will try to scan for codes and i will check fuel pressure asap. serial number M 025579 496 mag. thanks for any help

AllDodge 06-19-2022 07:01 PM

I'm thinking the injector driver but need the scan to verify

bobz71 06-20-2022 07:29 AM

ok i should be getting it scanned tomorrow, i hope, i will let you know asap.

bobz71 06-20-2022 07:36 AM

also is the injector driver an internal part of the computer? just curious?

DrFeelgood 06-20-2022 08:27 AM


Originally Posted by bobz71 (Post 4835894)
also is the injector driver an internal part of the computer? just curious?

Yes, it's internal to the ECM

bobz71 06-22-2022 07:52 PM

so havent had it scanned yet, waiting on adapter for the 496 then ill see, thanks again Bob

bobz71 06-23-2022 01:01 PM

so i switched computer from working good motor to running bad motor, did the same problem to the original running bad motor thus i believe ruling out a computer issue. also test pressure at rail turn key on 43 psi, then slowly drops then start motor stays steady at 36ish psi both motors do exactly the same numbers.

SB 06-23-2022 01:10 PM

As far as fuel pump staying on, i would suspect relay first ? I think.


All times are GMT -5. The time now is 09:52 PM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.