Tunellcram
07-21-2022, 09:20 AM
#11
Registered
The following 3 users liked this post by cheech:
07-21-2022, 10:06 AM
#12
That is cool. The only two downsides I see are the 1000 lb lead keel required to keep the boat from being top heavy and the fact that the intake charge is at 1000' MSL. 
J/K, keep up the great work.
J/K, keep up the great work.
The following users liked this post:
ICDEDPPL (07-21-2022)
07-21-2022, 10:50 AM
#13
Registered
iTrader: (1)
Looks great.
Still waiting for pics on air redirection things people make in plenum to distribute air from rear exit whipples.
this was an issue on these motors too, right ?
Still waiting for pics on air redirection things people make in plenum to distribute air from rear exit whipples.
this was an issue on these motors too, right ?
07-21-2022, 06:07 PM
#15
a 12 02 dyno will tell me more.
The following users liked this post:
Gimme Fuel (07-22-2022)
01-30-2023, 01:30 PM
#17
Tunnel crams have been shortened and ported (well one so far since November) and I can start putting everything back on my longblocks.
I now have around $3600/intake into these, I could have just bought a custom sheet metal intake so kids don`t be a dummy like me and instead of having Tunnel Rams modfied for port injection and then shortened because they are too tall , just custom make one, thanx .
Learn from my mistakes.
I now have around $3600/intake into these, I could have just bought a custom sheet metal intake so kids don`t be a dummy like me and instead of having Tunnel Rams modfied for port injection and then shortened because they are too tall , just custom make one, thanx .
Learn from my mistakes.
Last edited by ICDEDPPL; 01-30-2023 at 01:34 PM.
The following 6 users liked this post by ICDEDPPL:
Gimme Fuel (01-31-2023), Griff (02-02-2023), hogie roll (01-30-2023), ksalmine (02-05-2023), KWright (02-05-2023), OPS VZLA (02-04-2023)
01-30-2023, 02:11 PM
#18
VIP Member
VIP Member
On a good note....yea you have a ton of money in them but at least you will be the only with them and as usual with everything you do they look absolutely b!tchin!!!! Would have been cool to do a back to back dyno pull to see what you get out of just the intakes alone......
02-04-2023, 07:15 AM
#19
Platinum Member
Platinum Member
iTrader: (1)
So did they simply milled down the plenum a good amount, they did NOT cut runners off and reattach to plenum, correct? If so, how tall was plenum before, how tall is it now, thanks, Smitty
The following 3 users liked this post by ICDEDPPL:
