|
Originally Posted by DrFeelgood
(Post 4841546)
Eickert manifolds are NLA with no date of being available again at this time.
Cast overseas? Material shortage? Not enough demand? |
Originally Posted by cheech
(Post 4841580)
Any word on what is up with that situation?
Cast overseas? Material shortage? Not enough demand? |
Originally Posted by DrFeelgood
(Post 4841585)
I didn't ask the "why". I asked if there was an ETA, and I got a laugh, and a "no". I figured that told me all I needed to know.
I only have (1) set of SM manifolds left, that up at Mystic, sorry sold the other set last week. I do have (2) sets of Eikerts, but I'm inclined to keep those... I'll call you in a minute. MD |
Originally Posted by fbc25el
(Post 4841561)
I use 1/16 high temperature rubber and cut the gaskets out of that. I think the vibration will cut through RTV.
|
Originally Posted by Wildman_grafix
(Post 4842037)
Why not just use the gaskets made for that joint? I have never had a issue when I did, and hate to say have replaced them more then a few times. LOL
|
Originally Posted by DrFeelgood
(Post 4842039)
Maybe the rubber is reusable?
|
that funny right there ^^^^^^:party-smiley-048:
|
Originally Posted by F-2 Speedy
(Post 4842069)
that funny right there ^^^^^^:party-smiley-048:
|
SB's on fire today!
|
Originally Posted by SB
(Post 4842070)
Lol. Now read the title to this thread. Lololol
https://cimg7.ibsrv.net/gimg/www.off...f1a0306f20.jpg |
| All times are GMT -5. The time now is 12:45 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.