HD Hub Kit 1.25 Prop Shaft?
 

I see a couple variations for this application and was just wondering if this would be correct for my Imco shorty 1.25. Thanks

https://i.ebayimg.com/images/g/2RoAA...G/s-l1600.webp

https://i.ebayimg.com/images/g/~yAAA...xG/s-l500.webp

That's the one you need.

Thanks Brother. Any idea why some have three washers and one nut as compared to this one with two nuts and a washer? Is one just an updated version? Curious.

Honestly I didnt pay attention to the 2 nuts in the package. You are correct the should be 2 heavy washers, 1 crush washer and 1 nut. Alot of time when you see these used the crush washer is long gone, which really doesn't affect anything. The part number is correct though. I have about 8 of these extra that I am going to sell now that my prop shafts are 1 7/16.

Deep, Bencini,

For my ever-increasing knowledge base....

Is there anything "sacrificial" about that? Or is it just for when you've abandoned saving the outdrive/propshaft in lieu of performance, and accepted the potential for damage to the outdrive/propshaft?

Thanks. Brad.

Damn, the one in the pic is on the way from Kansas City, MO and was a deal for a new Merc part. I couldn't pass on it.

Brad, I ran the 1" set up behind a blue HP500 for 15 years with not so much as a dinged prop ever. High x on my cat and prop shaft soon to be 2" higher. That being said, I believe the rubber strips are designed to be the weak point in case of an underwater strike.

https://cimg6.ibsrv.net/gimg/www.off...fc941a563d.jpg

those nuts look small, I think mine are 1-1/8 socket size......but s Chris said it looks correct.IDK could just be the pic

I guess I'll find out in a few days. So I take it you have the double nut version.

no single