500 EFI fuel lines
Anyone have experience upgrading the fuel lines on the 500EFI?
I'm putting Aeroquip -8 fitttings from the tanks up to the filter but the stock filter has a 1/4" fitting. Any ideas? Is there a better filter that will bolt on? Will this cause any problems? Thanks |
HP500EFI Fuel Lines
We used -6 rather then -8 with no problems. There is really no advantage to the bigger line since the fuel filter and cool fuel will ultimately determine flow. I did end up with -8 in the Camaro but it was already there and I wasn't using the cool fuel or filter anyway. Biggest issue to contend with (in the boat) is corrosion (of the anodized aluminum fittings) unless you go with stainless or nickle coated.
|
If you feel you need larger fittings on the filter housing, you can drill and retap them to 3/8npt.
|
I can't believe 500 h.p. is supported with 1/4" line but everyone says you need 1/2" or 5/8" to support 700-800 hp.
I was going to install a Whipple so I was already upgrading the fuel lines to -8 but the whipple system doesn't use the factory fuel filter. Now I'm not installing it so all the fittings and hoses are on up to the factory filter. |
All times are GMT -5. The time now is 04:58 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.