exhaust block off plate
 

The stock merc exhaust blockoff plate. Does anybody know what it is made of? Stainless or is it steel? I doubt that it's aluminum.

I had a few that were powder coated aluminum and some others punched carbon steel. The transom assy.
is cast anyway.

cord
 

The old ones 1990 series had been made out of alum. the newer ones are steel. i just made a new one out of stainless about a month ago. I still have the old alum. one if you need it. I will just have to find it.

Yes, I would be interested in the aluminum one. How much do you want for it? Can I get it soonly?

262-243-9663 [email protected]

Re: cord
 

I need 2 as well (not to interrupt cords thread, not pun instended). If you have the pattern or some extra SS I'd be interested.

sorry
 

I only made one stainless off the stamped steel plate.the other Im sending to cord.

bajalion
 

I can trace the plate to get you the pattern and might have some stainless steel flat stock. Ill be in touch tomorrow.

baja-I know of a laser guy that could cut them out of stainless. He's not cheap though. It would proably cost you $75 plus the material. Heck, if you did that, I'd even polish them for you. :D

pt # 861776A2 from Merc $38
or from CP performance...........block off plate

Had a dozen trim pump brackets made. I guess I'll have some of these made as well.

I have a few friends that can do this. They basically say if I make one or 10 it's about the same price. Set up is the PITA.

soonly????

:rolleyes:

Shurly. :D

Cord,
I have an extra one, not sure if it is steel or what.. been awhile since I bumped into it..

It is brand new, Merc piece..

Email me if you are interested..

Dick

I will do that mr G, lets see if 454hoho can find that aluminum one. Aluminum would fit perfectly into my wicked plans! Whoohahhaa...

cord
 

found plate, going to post office in next half hour to ship it to you. This is the alum. plate approx. .38 thick, hope it helps

It absolutly will! Thanks!