Masterlube Installation ???
 

ok, asked this question in general area with no takers.
Where is the best location to tap into the motor or oil filter location from the masterlube cylinder. The motor is a 500EFI, and it will be used as a preluber?
Suggestions??

I too wondered this, but I found that a bottom of the webpage

http://accusump.com/acc_products/acc_units.html

unit is easier to install

I put a couple of those on some boats. Where the oil sender is, I put a tee there, oil sender on one side and the Masterlube hose on the other side. No problems w/ 2 seasons.

otherside of what dont you need the intake for the masterlube on the pan?

:confused::confused: :confused:

I have one of these installed on my 575sci which should be the same install as the 500efi. I'll have to look but I think it's installed to a oil rail plug that's easy to remove on the port side.

Yes, any one of the rail plugs can be used. The port side has several. I use the one next to the oil sender.