Tailpipe transom grommets
 

I have a 91 32 fever and am installing new exhaust.
Where my existing tailpipes pass thru the transom grommets,its a little sloppy.Does anyone know where I can buy exact replacements for these? Rex's are three
bolt & mine are four. Could I just put some sealer in
there ? Does it have to be a real tight fit? Any help
appreciated. Rick

My Fountains have just had a 4 screw hole plastic ring slide over the tail pipes, no gasket. But the space between the tail pipe and the transom cutout is filled with sealer. I use 4200 with no problems.

IMCO sells the 4 hole silicone gaskets and the trim rings if you need them.
And yes!!!! they need to be tight. Starts out as a 2" hole and goes to 4" when you push the pipe thru.
I need to get my mind out of the gutter:rolleyes:

Dan:cool:

Don't forget to call Brownie at Stainless Marine - (305) 681-7893. They make these by the hundreds.

Thanks guys. Always get the answer on OSO!