Water pressure gauge Tap?
I want to put a water pressure gauge in but i'm not sure where to put the tap to measure the pressure so what do you guy think is the best location? My boat has a through hull raw water pump as well as the engine circulating pump. Thanks for any suggestions, Eric.
|
Install a fitting in the block drain hole.
|
Or the intake.
|
Re: Water pressure gauge Tap?
take airpackers advice
|
Re: Water pressure gauge Tap?
My past three have been on the t-stat housing :)
|
Re: Water pressure gauge Tap?
Mine was in the block drain hole, when I had an engine.
|
Re: Water pressure gauge Tap?
Mine is in the block drain hole also.
|
Re: Water pressure gauge Tap?
both of mine are in the drain holes.
|
Re: Water pressure gauge Tap?
ok, ever get clogged with dirt???
|
Re: Water pressure gauge Tap?
Never clogged but have seen a couple pieces of debris in the clear polyflo tubing I used.
|
All times are GMT -5. The time now is 04:18 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.