Re: Can Not Figure It Out,,Please Help
 

Are you certain the drives are trimming evenly? One higher than the other will have this affect. Also, you may want to take measurements on the toe in/ toe out setting of the two drives.

BT :cool:

Re: Can Not Figure It Out,,Please Help
 

yes checked the trim on them and even played with just one trim at a time while cruising the only way I could get the stb side to match the rpms if it comes close to cavitating(not sure if its called that or not)

Re: Can Not Figure It Out,,Please Help
 

also not sure about the toe in toe out thing at all. not sure how to check or set it

Re: Can Not Figure It Out,,Please Help
 

Do you spin the props in or out?

Re: Can Not Figure It Out,,Please Help
 

props spin out

Re: Can Not Figure It Out,,Please Help
 

This is checked by measuring the distance between the leading edge of the drive (edge closest to the boat) and the distance between the exact center of the prop shafts. Toe in is the leading edge measurement is closer than the measurement of the prop shaft. Normally, you want these to be exact, unless you want to play with it some to see what makes the most speed. For troubleshooting your problem it would be recommended to get them to match. Please note this measurement needs to be done as exactly as possible as small differences make significant differences in performance.

Re: Can Not Figure It Out,,Please Help
 

With the drives straight ahead, use a tape measure to get the measurement between the drives at the front of the bullet. Then measure center to center between the ends of the prop shalf centers. For spinning out I would have the prop shaft centers further apart than the front of the bullet by about 1/8". This is at least a good starting point. You adjust the tie bar.

BT :cool:

Re: Can Not Figure It Out,,Please Help
 

just checked the toe in toe out thing and it is dead on the money both are exactly 35 inches

Re: Can Not Figure It Out,,Please Help
 

How tight are the drive hinge pins and gimble pin? Any noticable slop up/down left or right? Are there any sea water pickups, transducers, trim tabs or anything else that may be causing turbulation on that side?

Re: Can Not Figure It Out,,Please Help
 

everything is tight I checked all that when the foot was rebuilt. nothing loose or any play.