Gale Banks Cam
 

Does anybody know where I can find a Banks cam no. GBE*E6SCH41L. This is a hyd flat tapet 114*lobe center,.559lift.244*@.050 intake&exhaust.Lost an exhaust lobe after 18yrs.service.The cam mfgs dont have much info for turbo engines. Thanks Jack.

Re: Gale Banks Cam
 

I had better luck with the chev LS6 cam. It was a flat tappet cam. At least I think that was the cam. It was also on the 114 centerline. I think crane makes a equal to it.

For Turbo Cams I think the only one that still has them listed is crowler.

Re: Gale Banks Cam
 

http://www.crower.com/misc/m_cat.shtml
page 45 these are not as wild as what you are saying that cam is.

If you call them they also have some grinds they do not list.

Re: Gale Banks Cam
 

If you have the cam or know the profile someone can do a custom grind and duplicate it. I know Erson will and probably most other reputable cam mfg's.

Re: Gale Banks Cam
 

Turbo Jack and Wet Vette Thanks for replies and info. I will wait & see if one of these surfaces, no hurry right now. I run rhodes lifters due to the 244*duration. It idles easily at 800 and 600 in gear with 34 bravo. I know I'm leaving some on the table but 100-102 is fast enough for my 23 1/2 footer. With this setup I don't have to service valvetrane components on a regular basis. If I don't find this cam I will have one ground identical.

Re: Gale Banks Cam
 

ttt

cam
 

I have one of these cams if you are still looking for one.Its used out of a jet boat motor I bought.I have it on craigslist for 80obo you can email me at [email protected] or call me at 832 384 2936 :cartman:

Personally I would have Cam Motion make it.

They do great work and will build anything.

Cam Motion, Inc.
2092 Dallas Drive
Baton Rouge, LA 70806

[email protected]

Telephone:+1 225 926 6110
Fax:+1 225 923 2101

http://www.cammotion.com/

Turbo engines too


Good Luck
Jon

8 year old thread

I had comp cam make one 2 yrs ago.
HR 114 lobe sep 243* @ .050 int and ex
.627 lift intake and exhaust