1995 32 hustler bolster bottoms
 

just picked up a new project for me
1995 32 hustler
this hull i guess is 1 of his 1rst to do lots of foam coring in the hull layup
as was told started on a couple then,,,and see it in the cutouts
as the rear hatch,,,,top deck ,,all birth boxing for benches ,ect
only has a sink in birth ,,,,nothing else but cushions
so a lighter version is a good start for me

the bolster have no drop bottoms,,,stand up only
so checking if any1 has some bottoms
also with bolsters built in the gunnels
they are too close to dash to sit in my opinion
so going to vut loose from gunnel walls and glass back 6" or so further back
as i like to sit on fun rides,,,,
also can just pick up some free standing bolsters
but like to keep the oem as already been reaupulstered,,new awlcraft paint done in 2019
so good starting point for 2021/22 upgrade on all guages,wiring,electronics,,ect
also probably reglass the driver dash to raise the steering helm for the angle i like
old school being kinda low and staight out not for my seating position i like

if any1 has and bolster bottoms and swing mechanism i could get id appreciate
i can make my own but if do that probably just get some nice standalones
tks john