The 3 man is getting some mney dumped into her
#32
Registered
Platinum Member
Thread Starter
Hull is coming along good. The reason the deck was breaking is because there was a bulkhead that was never bonded to the deck on the starboard side. Wood was roting a little because moisture was penetrating. Bulkhead is getting fixed and adding a brace underneath.
Adding 1 of these vents on both sides and running 4" PVC to plum additional air into the engine compartment from these vents. I don't want to put scoops on the engine hatch, because I just don't like them.
These vents should work just as good as a scoop, if not better because I can channel the airflow where I want it to be.
I might even add 1 or more in fron of the fairing to ventilate the cockpit. Not sure on that yet.
Opinions?
Adding 1 of these vents on both sides and running 4" PVC to plum additional air into the engine compartment from these vents. I don't want to put scoops on the engine hatch, because I just don't like them.
These vents should work just as good as a scoop, if not better because I can channel the airflow where I want it to be.
I might even add 1 or more in fron of the fairing to ventilate the cockpit. Not sure on that yet.
Opinions?
#33
Registered
Platinum Member
Thread Starter
#34
Registered
Platinum Member
Thread Starter
Hatch doesn't have any holes in it. Those vents are up on the sides of the deck.
#36
Registered
Platinum Member
Thread Starter
#38
we'll get this out'a the Skater section so the Runni-a-muk guy can keep his precious logo thread un tainted
__________________
Throttles- Cleveland Construction 377 Talon
08 OPA Class 1 National Champion
08 Class 1 Geico Triple Crown Champion
08 OPA High Points Champion
10 OPA Class 1 National Champion ( happy now Ed! )
Throttles- Cleveland Construction 377 Talon
08 OPA Class 1 National Champion
08 Class 1 Geico Triple Crown Champion
08 OPA High Points Champion
10 OPA Class 1 National Champion ( happy now Ed! )
#39
Registered
Platinum Member
Thread Starter
Now let me look at this.
If I was to go racing with it one day, I would have to put vinyl over this paint job. Where would those go, and what would they look like?
#40
Registered
Platinum Member
Thread Starter
Instead of orange to yellow, can we go red to orange. Finish the orange towards the back of the boat where the seats have the orange in them. What are your thought on that?
Last edited by jeff1000man; 04-14-2009 at 09:39 PM.