If you are referring to mine, I still have to do some thing with the floor. Either fit the 450.00 worth of Zebre wood i bought 3 years ago or have a carpet made. As soon as I figure that out the last thing is tthe new interior installed. Insrament panal still needs to be replaced and I need a set of tachs. Make me an offer.

Mine was 7/16-1/2. The insert is app5/16 fiberglass. When i installed mine i ran a heavey bead( 1/2 dia)1/2 inches in from the edge. Ran the boarder screws down till the insert was flush to the deck. then ran a small bead betwween the deck and insert outer edge.

Mario...I'm about 99% sure the early Sports had a real wood inlay...like '68-'69ish...

Pulling its xr drives off my top gun, thinking of using them on magnum. Weight less than trs set ups and it would give a clean drive set up. IS THIS A BAD IDEA?

[ATTACH=CONFIG]534372[/ATTACH][ATTACH=CONFIG]534373[/ATTACH][ATTACH=CONFIG]534374[/ATTACH]
My buddy can't wait till January to start back up on Magnum. Starting to prime...
Plans to finish hull this winter.

Work slows down for me after January first, can't wait for that fiberglass itch again....

Greg I'm jealous, it's must be great to have a warm shop to work in during Michigan's long winter. Working under blue poly tarps just does not get it after October here in Michigan. Bill's Short Circuit Mag runs great since it was converted with the stock Bravo's, Xr drives should be stronger & better. Mark

Thanks for drive input. I was thinking the same. Still have the volvo trim motors and flex plates for you. Gonna head your way after the first of the year I can drop them off.

Thanks Greg that would be great, I been meaning to get down your way but it never happened.

Took some time off Magnum due to cigarette projects, back on track
https://cimg0.ibsrv.net/gimg/www.off...e7ff2231f.jpeg
Taking down gel coat and awlgrip off, down to fiberglass.