Four 500 EFI in the Floor
 

Picture tells it all.

Re: Four 500 EFI in the Floor
 

What to do, So many motors, so little time.

AS anybody made a monoblade unit out of these throttle bodies???

Re: Four 500 EFI in the Floor
 

Cut like this & Make a single blade. Mark tells me it can be done with a little skill. It dont look to be too hard.

Any Suggestions? If I fail, just buy one from Arizonia. Looks to be just like some head port work.

Re: Four 500 EFI in the Floor
 

Linster,
I haven't seen anyone do the cut. I agree it's probably not brain surgery, unless you mess up your brain :eek: ...........
I don't know what AZSM is getting for their monoblade, but I have seen it installed on a 500EFI, and it's a nice piece.
Mercury blue too :cool: .
Regards,
Steve

Re: Four 500 EFI in the Floor
 

Steve

They are $500 a piece, Ouch! May have to give up some time to see if I can make them work

LLH

Re: Four 500 EFI in the Floor
 

linster I would be willing to trade you two carb 500's for your two efi 500's. I will even buy the two throttlebodys and your beer for the Maryland trip. lol I will call you Sunday and let you know how the sea trail went.

Terry

Re: Four 500 EFI in the Floor
 

Hey linnie I think boost power does the monoblade conversion the think I gave you the magazine with the article in it I'll give you a call.

Re: Four 500 EFI in the Floor
 

[QUOTE=Linster]What to do, So many motors, so little time.QUOTE]

Sell me one of them! :D

Re: Four 500 EFI in the Floor
 

Are you sure...have you seen how much beer he can drink in 4 days!!!! :eek: :D

Re: Four 500 EFI in the Floor
 

[QUOTE=noboat]I would but Lotti would probally get mad.

Re: Four 500 EFI in the Floor
 

Linnie this is the mono blade ya need :drink:

Re: Four 500 EFI in the Floor
 

Here are some pictures of the one Richie Zul made himself. He said on the dyno it was around 25 hp . He also made a Phonoic[wood] spacer for it that was shaped like a horn to help air flow.


Rob

Re: Four 500 EFI in the Floor
 

He also made this water circulator remover kit for the 500EFI. Looks like he spent a great deal of time coming up with this idea, I bet it works pretty good :D I believe he made around 648 hp out of this motor ..Stock appearing :drink:

Re: Four 500 EFI in the Floor
 

Rob

On the mone blade, Is that the one Zul did?

Cutting behind the the throttle body is the easy part. I bought a 525 EFI blade from merc ( $35 ). I am going to mill out the center, mill the shaft and work it that way. Will see how it works. Getting the blade to set well is going to be the trick.

Thanks for the input, Any other ideas, plesae forward

Re: Four 500 EFI in the Floor
 

Yea thats the one Richie did . he said it was worth it .