Engine hatch actuator
11-23-2008 | 08:52 AM
#1
Thread Starter
Registered
Joined: Apr 2007
Posts: 272
Likes: 0
From: Cartersville, GA
Engine hatch actuator
Anyone had one go out? What was Nordics plan B to get inside if this happens? A big hammer or saw? Mine is fine but it has just clicked on me a couple times, I had to bumped the switch a couple times before it moved, makes me nervous. Other mfgs have an access point where you can reach in and pull a pin to allow access. Just wondered if this has happened to anyone yet and what they did to get in.
11-23-2008 | 09:16 AM
#2
Registered
Joined: Dec 2007
Posts: 112
Likes: 0
From: Nashville Tn
hatch
you can unbolt the rear seat but i think you are going to find that the switch contacts have carbon built up on them. open up the switch and clean the contacts with some emory cloth it should work fine. oh you might have to adjust the contacts a little.
11-23-2008 | 11:54 AM
#3
Registered
Joined: Sep 2001
Posts: 1,751
Likes: 11
From: Cincinnati Ohio
Anyone had one go out? What was Nordics plan B to get inside if this happens? A big hammer or saw? Mine is fine but it has just clicked on me a couple times, I had to bumped the switch a couple times before it moved, makes me nervous. Other mfgs have an access point where you can reach in and pull a pin to allow access. Just wondered if this has happened to anyone yet and what they did to get in.
