![]() |
35 Flame setup questions
I am looking to do some upgrades over the winter to try and get my boat into the triple digits. I have an 03 Flame with Pfaff 700's, standard 1.5 XR lowers, turning 32B1 props. I am running around 93mph now. I think it should be a little faster. I have one -1 Imco lower, 1.5 ratio and I have 0ne standard length Imco lower 1.36 ratio. I can buy one of either to get a matched pair. Has anyone tried a pair of -1's on a Flame? I would think that the nosecones should help quite a bit at this speed, but what about the length? What about a proven prop for this hull? I have a pair of 30P B1's, but I haven't tried them yet. Thanks, Joe
|
i was told that my flame with the merc 700's ran at 130 mph. i bought it with stock 502's spinning B1 30's at 5200 and i was at 84 mph on gps. to me your way under speed for the engine package you have. and my outdrives are stock bravo ones 1.5 ratio.
|
also that is with 6 optima blue top batteries 3 people and 1/2 tank of fuel.
|
I put on the -1 lowers and I am going to dunk it tomorrow and see what happens. I have some serious doubts about 130mph with 700's. I don't think a flame has ever been that fast. That is about what a Skater runs with 700s
|
Originally Posted by snapmorgan
(Post 4621233)
I put on the -1 lowers and I am going to dunk it tomorrow and see what happens. I have some serious doubts about 130mph with 700's. I don't think a flame has ever been that fast. That is about what a Skater runs with 700s
There was a flame for sale over winter with pro charged 500s - I know the guy who built the boat and it ran 105-110,,,I don't see 700s doing 130, ever. |
Mine has does just shy of 110 with 600Merc & Stg 3 whipple kits. 107 I think is what it did.
|
Originally Posted by JD Dearden
(Post 4621310)
Mine has does just shy of 110 with 600Merc & Stg 3 whipple kits. 107 I think is what it did.
|
-1 lowers didn't work well for me. Had a very hard time getting on plane. It did pick up some top end though. Ran it up to 95 in less than ideal conditions until the chine walk got so bad that I had to back off. I might cure it with some 5 blade props and some longer tabs, but at some point, enough is enough.
|
Originally Posted by snapmorgan
(Post 4621569)
What drives and props?
XR drives with stock merc 32's 4 blades |
Originally Posted by snapmorgan
(Post 4621814)
-1 lowers didn't work well for me. Had a very hard time getting on plane. It did pick up some top end though. Ran it up to 95 in less than ideal conditions until the chine walk got so bad that I had to back off. I might cure it with some 5 blade props and some longer tabs, but at some point, enough is enough.
|
That is what I am thinking. Going to ditch the -1 lowers and add nosecones to my XR lowers. Thanks
|
Originally Posted by JD Dearden
(Post 4621310)
Mine has does just shy of 110 with 600Merc & Stg 3 whipple kits. 107 I think is what it did.
|
Originally Posted by jackstand
(Post 4623006)
I bought that procharged boat.. not sure what it runs yet only had it out a few times but also read the original owner builder went 107. The previous owner said 103
|
Originally Posted by jackstand
(Post 4623006)
I bought that procharged boat.. not sure what it runs yet only had it out a few times but also read the original owner builder went 107. The previous owner said 103
|
Originally Posted by MINK
(Post 4623077)
You got a good deal on a sweet ride.
Originally Posted by JD Dearden
(Post 4623111)
Not sure which Flame that is...
I tried posting a picture but don't have enough posts |
Its the one with the blue checker board that goes up on the hatch right?? if so...super jealous...well jealous of the flame in general..would have def put an offer in on that if I hadn't bought my heat already lol...sweet rig
|
Yes that's the one.
|
very nice...sorry to hijack your thread snap lol
jackstand...you should start a new thread in the Nordic section or wherever introducing yourself and make a few numbered posts till you get enough for pics :evilb: |
Originally Posted by BBYSTWY
(Post 4623214)
very nice...sorry to hijack your thread snap lol
jackstand...you should start a new thread in the Nordic section or wherever introducing yourself and make a few numbered posts till you get enough for pics :evilb: Finally enough posts.. lovely cruiser wake 😐 |
Jealous!!! lookin good!!
|
| All times are GMT -5. The time now is 06:10 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.