steering wheel center cap removal '04 Heat
#1
Registered
Thread Starter
steering wheel center cap removal '04 Heat
I'm trying to remove the factory center cap without damaging it. I can get a razor blade to go into the joint between the cap and the wheel in a few spots. I can't get it to budge. How is it held on? I don't see any set screws or other exterior means it's held together.
Thanks guys.
Thanks guys.
Last edited by 87MirageIntruder; 11-27-2018 at 05:31 PM.
#2
Registered
Join Date: Apr 2014
Posts: 229
Likes: 0
Received 0 Likes
on
0 Posts
It is glued in pick up a set of soft pry tools they are nylon they wont damage aluminum they are wedge like tools can probably get a set from harbor freight or similar. Take soft pry and a hammer where you have been putting blade and tap away once you get pry tool in there you should have a gap then just work your way around with another soft pry hope this makes sense and helps you
#3
Registered
Thread Starter
Thank you so much! I will try that.
#4
Registered
After I pulled the steering wheel center cap. I threaded the back and used it in place or the tow pole. I never towed anything and it seemed to be in the way all the time.