![]() |
Re: Let's see Pics of your OE
Change the chainbox fluid and u-joint fluid. Look for milkly fluid. You should order boots for those drives.
|
Re: Let's see Pics of your OE
I did the oil already, now i have to do the drive, Mark can u post a pics of what a boots look like, these drives are second effort drives,they have * inch extention on the prop shaft
Lenny |
Re: Let's see Pics of your OE
Originally Posted by lamdenali
Mark can u post a pics of what a boots look likeLenny
What did the oil look like after running? It should be ran a couple times on a hose and changed again before splashing. |
Re: Let's see Pics of your OE
EX39
Just was wondering if you dropped the new power in and have you had a chance to get on the water? What kind of numbers on the water and or dyno? |
Re: Let's see Pics of your OE
1 Attachment(s)
Minutes before dropping in.
|
Re: Let's see Pics of your OE
I need a contingency plan just in case I cant find the right 39' so I was wondering what is your guys opinion of the 33'?
Mind you I'll be running in the Gulf. Is a 33' to small? Will there be a big difference in fuel consumption$$$? (lighter boat=less gas) or is this a non issue? Is the cabin design somewhat similar? (just slightly smaller) Anyone know the tunnel width? I know they have 10' beams. Insurance, is there a difference between the two? Dare I say it. But should I be considering 38' Top Gun instead of a 33' for plan B :eek: I just dont want to make a 100k mistake. Thank you AL. |
Re: Let's see Pics of your OE
1 Attachment(s)
Port installed
|
Re: Let's see Pics of your OE
1 Attachment(s)
Stdb installed
|
Re: Let's see Pics of your OE
Originally Posted by ChiToWn TapouT
EX39
Just was wondering if you dropped the new power in and have you had a chance to get on the water? What kind of numbers on the water and or dyno? Dyno'd @ 1100 HP. |
Re: Let's see Pics of your OE
Originally Posted by expresscat39
Lenny, all they are is like the black rubber convoluted boot that encloses the u joint on a bravo drive train.
What did the oil look like after running? It should be ran a couple times on a hose and changed again before splashing. after 2 run I check the oil it look clean , there is no change in color |
| All times are GMT -5. The time now is 07:28 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.