Like Tree0Likes

Electronic Sender Suitable For Fuel, Diesel And Water

Reply
Old 01-14-2011, 06:40 PM
  #1
Administrators
Thread Starter
 
KennyOffShore's Avatar
 
Join Date: Apr 2008
Posts: 854
Default Electronic Sender Suitable For Fuel, Diesel And Water

This sender is constructed to meet and/or exceed all applicable ISO, NMMA/ABYC and USCG standards. Easy to install, the fuel/water sender uses the SAE 5 hole pattern; constructed of 316 stainless steel and fully insulated to protect against voltage inside the tank. The float is the only moving part of the sensor minimizing mechanical failure. Best of all, there is no calibration required.

How It Works
Measurement is achieved by a series of reed switches positioned inside the level tube. The float with built in magnets then triggers the reed relays generating a potential - free resistance with an ohm value that increases or decreases.

Options
Livorsi carries 240-33 OHMS in stock. Other resistance outputs or senders with a 1 1/4"or 1 1/2" NPT are available upon request.
The sending unit length should be a minimum of one (1) inch less than the depth of the tank.

For more information please call Livorsi Marine at 847.752.2700
KennyOffShore is offline  
Reply With Quote
Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -5. The time now is 12:33 PM.


Copyright 2011 OffShoreOnly. All rights reserved.