rchevelle71

iTrader: (1)

Make sure you add more than just mat, needs some woven, or cloth.

no limits

Ground down all unwanted holes to later fill with glass and then grind down again.

no limits

Don't have pic, but woven is the final layer and is done.

no limits

another of holes to be filled.

no limits

Skipping a step here (don't have pic), but holes were filled out with glass and then ground down for finish. Basically a bondo.

no limits

Transom is ready for gel. Hoping for this coming Monday. This is how boat looks now. Obviously not showing all steps up till this point, but you can see some. In between there is lots of grinding, filling and more grinding, sanding, etc. Looking forward to getting her done.

no limits

That's ok. Got it going now.

rchevelle71

iTrader: (1)

Looking good!!!!

no limits

thanks.

no limits

I found a hole in my gas tank. I knew it was bad and didn't use it last year. Boat has 2 tanks, a 30 gal. in the front and I am assuming a 60 gal. in the floor. Unfortunately for me the 60 gal. has the hole. Found it was leaking from the back. Found the hole and proceeded to patch. Thought I got lucky and hole was near the top as shown in pic. However one hole turned out to be multiple holes, some of which could not be seen. I decided not to pull tank out this year if I ever plan to run this Spring/Summer.