i only sprayed it because i bought all the spray converters etc but if i were to do again id roll it. Its too tight of and area to spray and look good and it all runs to the keel. Itll work for a race boat thought well see how it cures up.

thanks Jeff were hammering down. Transom painting this week then dropping the engine in.

https://cimg4.ibsrv.net/gimg/www.off...f752407cd.jpeg
Transom painted. Went black to break it up came out decent. Time to start rigging it!
https://cimg5.ibsrv.net/gimg/www.off...9b03d68cb.jpeg
Sanded and buffed it. Awlcraft se with 3000 clear over it. Reflection test

Dash made by the trim king himself Nick. This boat is no where near square and on some goofy angles. Guy took a few measurements on scratch paper and made this at his house in an hour dropped right in. Guys a wood wizard. Primer got laid down on everything after this dash will be glassed and painted.
https://cimg1.ibsrv.net/gimg/www.off...5ac6bc666.jpeg
https://cimg2.ibsrv.net/gimg/www.off...e5ad3a362.jpeg

What is that hole on top of the dash for?

the old compass was there. Still deciding how the top will be and if were putting one back in or not.

Is'nt a compass mandatory?

thats what i thought and if you build by the rulebook it states yes but i see all these boats without them so not sure if now a gps counts as one? Thats why we left the hole

https://cimg1.ibsrv.net/gimg/www.off...fb96c5234.jpeg
https://cimg3.ibsrv.net/gimg/www.off...cc431bdd1.jpeg
https://cimg5.ibsrv.net/gimg/www.off...80f8e1a27.jpeg
All in finish primer sanding today and final paint tomorrow

Woo hoo !!!
that must feel good!