Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 10
1
2
3
Last »
Search: Posts Made By: snapmorgan
Showing results 1 to 25 of 240
Search took 0.01 seconds.
Forum: General Boating Discussion
04-30-2024, 09:30 AM
Replies: 9
Views: 569
Posted By snapmorgan

So I was Eddie Young's guinea pig for the 575...

So I was Eddie Young's guinea pig for the 575 throttle body/ injector plate setup. The prototype and tuning was done with my engine. Pretty much the only 575 specific issues that I had with mine in...
Forum: General Q & A
04-29-2024, 12:01 PM
Replies: 28
Views: 905
Posted By snapmorgan

I have personally never seen a BBC combo that...

I have personally never seen a BBC combo that wouldn't tolerate 35 deg timing, but I guess it could happen. I would ask the engine builders opinion if there is any type of warranty involved.
Forum: General Boating Discussion
04-29-2024, 09:41 AM
Replies: 9
Views: 569
Posted By snapmorgan

I loved the one that I had. In stock form they...

I loved the one that I had. In stock form they have a flat tappet cam and iron heads. That looks like it has been addressed with these builds.. I believe the injectors are NLA, but with the YPM...
Forum: Cigarette
04-29-2024, 09:35 AM
Replies: 193
Views: 28,598
Posted By snapmorgan

I added the second (lower) tie bar on my 35...

I added the second (lower) tie bar on my 35 Nordic to use as a boarding ladder. It worked great and there was no binding. Unless you have a ladder, i would leave it alone.
Forum: General Q & A
04-29-2024, 09:24 AM
Replies: 28
Views: 905
Posted By snapmorgan

I would set the base timing by where it likes to...

I would set the base timing by where it likes to idle and start well. That may be 10 deg or 20 deg or anywhere in between. Give it 35deg total and I would use the springs that are all in at about...
Forum: General Boating Discussion
04-12-2024, 10:33 AM
Replies: 19
Views: 1,688
Posted By snapmorgan

I do not, I use the automotive version in the...

I do not, I use the automotive version in the dark blue bottle
Forum: Cigarette
04-05-2024, 12:14 PM
Replies: 193
Views: 28,598
Posted By snapmorgan

Those are some big power numbers for a 454 with...

Those are some big power numbers for a 454 with boat friendly compression and a reversion free camshaft.
Forum: General Boating Discussion
04-05-2024, 07:52 AM
Replies: 19
Views: 1,688
Posted By snapmorgan

I like the Lucas slick mist speed wax. Can get it...

I like the Lucas slick mist speed wax. Can get it anywhere.
Forum: Boating Safety
03-20-2024, 11:58 AM
Replies: 5
Views: 666
Posted By snapmorgan

These are pretty cool too. I have used them...

These are pretty cool too. I have used them several times.

Domed Boat Lettering | DomedLettering.com (https://domedlettering.com/create/?source=bing&msclkid=61cac613e6fc113bc633a3e8f3a5f5bf)
Forum: General Boating Discussion
02-13-2024, 11:58 AM
Replies: 9
Views: 645
Posted By snapmorgan

Someone a few blocks away from me has one of...

Someone a few blocks away from me has one of these boats. It is black and white, has 911 on it i think. Does this boat actually race?
Forum: Activator
02-07-2024, 08:02 AM
Replies: 109
Views: 10,267
Posted By snapmorgan

I could certainly be wrong, but I would think...

I could certainly be wrong, but I would think that at 28 deg total timing these engines are probably down 50 hp and I would be concerned with tuliping the exhaust valves or torching the seats. I...
Forum: Trucks, Trailers and Transportation
01-29-2024, 01:38 PM
Replies: 28
Views: 3,110
Posted By snapmorgan

The trailer lights are on so it must at least be...

The trailer lights are on so it must at least be plugged in to that midget SUV.
Forum: General Q & A
01-16-2024, 07:53 AM
Replies: 11
Views: 1,173
Posted By snapmorgan

I had a pair of 565's with the 500EFI intakes...

I had a pair of 565's with the 500EFI intakes that were extrude honed by ASM. Couldn't have been happier with them. Made about 700/700
Forum: General Q & A
12-29-2023, 08:23 AM
Replies: 17
Views: 1,647
Posted By snapmorgan

Pretty sure that i read where the OP has...

Pretty sure that i read where the OP has purchased a set of "roval" heads. I seriously doubt that the intake will be a restriction and no amount of porting is going to help the situation. Maybe...
Forum: General Q & A
12-28-2023, 07:38 AM
Replies: 17
Views: 1,647
Posted By snapmorgan

I had an ASM extrude honed one that was given to...

I had an ASM extrude honed one that was given to me by Haxby. It picked up 30hp over a stock intake on a very mild 540 with no other changes.
Forum: General Boating Discussion
11-30-2023, 10:16 AM
Replies: 22
Views: 2,654
Posted By snapmorgan

While I have never owned a Heat, I did own a 35...

While I have never owned a Heat, I did own a 35 Nordic Flame for 3 or 4 seasons. I wasn't impressed at all with the build quality of the Nordic. I can assure you that the build quality of the 3...
Forum: General Q & A
11-30-2023, 09:50 AM
Replies: 33
Views: 2,881
Posted By snapmorgan

I like your style. Concerns about the engine, no...

I like your style. Concerns about the engine, no problem, lets just pull it and put it on the dyno. If more people took your approach, they would save hours, days, even months of troubleshooting.
Forum: General Boating Discussion
11-29-2023, 08:28 AM
Replies: 22
Views: 2,654
Posted By snapmorgan

If I were on the West coast looking for a boat to...

If I were on the West coast looking for a boat to use on the West coast, I would be looking at west coast boats. The 27 Fountain wouldn't be on the list. Laveycraft, Warlock, Advantage, Nordic,...
Forum: General Q & A
11-10-2023, 01:10 PM
Replies: 13
Views: 1,346
Posted By snapmorgan

Yes, the stock GM performance dogbone lifter.

Yes, the stock GM performance dogbone lifter.
Forum: General Q & A
11-09-2023, 12:51 PM
Replies: 13
Views: 1,346
Posted By snapmorgan

I have ran the dogbone lifters with 450# over the...

I have ran the dogbone lifters with 450# over the nose at .635 lift at 7000 rpm in a boat engine with no ill effects.
Forum: General Q & A
11-08-2023, 02:58 PM
Replies: 13
Views: 1,346
Posted By snapmorgan

I wouldn't spend any money on an old set of GM...

I wouldn't spend any money on an old set of GM oval ports trying to make power. The aftermarket stuff is so far superior that it just doesn't make sense .
Forum: General Boating Discussion
11-07-2023, 07:23 AM
Replies: 65
Views: 7,338
Posted By snapmorgan

Yes, but would you take 25K for it? I...

Yes, but would you take 25K for it?

I believe a 27 Fountain at 25K would be a basket case that would need at least another 25K spent on it. You are probably going to be more in the range of a 90's...
Forum: General Q & A
11-06-2023, 01:00 PM
Replies: 35
Views: 2,609
Posted By snapmorgan

Could be as simple as a piece of trash in one of...

Could be as simple as a piece of trash in one of the needle valves. I had it happen to me when I made a new fuel line.
Forum: Midwest
10-27-2023, 03:02 PM
Replies: 125
Views: 16,825
Posted By snapmorgan

There were 19 condo buildings in the association....

There were 19 condo buildings in the association. They would put 1 new roof on every year that came out of that fund. Oldest roof would never be over 20 years old. It worked well.
Forum: General Q & A
10-24-2023, 11:24 AM
Replies: 11
Views: 1,438
Posted By snapmorgan

The IMCO lower should supply plenty of water at...

The IMCO lower should supply plenty of water at speed to keep the intercooler pressurized. You may even have to put a pressure regulator on it depending on your water pressure.
Showing results 1 to 25 of 240
 
Page 1 of 10
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.