Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: sailtexas186548
Showing results 1 to 25 of 52
Search took 0.01 seconds.
Forum: General Q & A
06-30-2023, 04:04 PM
Replies: 16
Views: 1,276
Posted By sailtexas186548

Super Alloy Exhaust and 6000 series intake, great...

Super Alloy Exhaust and 6000 series intake, great valves
Forum: Wanted
05-07-2023, 12:44 PM
Replies: 6
Views: 505
Posted By sailtexas186548

they are $21 on summit not even worth trying to...

they are $21 on summit not even worth trying to DIY one IMO

https://www.summitracing.com/parts/SUM-901015
Forum: Scarab
04-05-2023, 02:48 PM
Replies: 3
Views: 1,135
Posted By sailtexas186548

Fifth or sixth times the charm! All this talk...

Fifth or sixth times the charm! All this talk about rotted transoms seems like it all rots in The end!
03-13-2023, 10:03 PM
Replies: 17
Views: 2,244
Posted By sailtexas186548

Ill post up once I get the glass work done, a few...

Ill post up once I get the glass work done, a few months and I should be there
Forum: Cigarette
11-09-2022, 07:55 AM
Replies: 109
Views: 21,111
Posted By sailtexas186548

I think the spacer idea is a good one if you have...

I think the spacer idea is a good one if you have the room to play with. Don’t even need to water jacket it, just have the parts on hand to build that small section once you set the engines you can...
Forum: General Q & A
10-20-2022, 07:12 PM
Replies: 33
Views: 4,418
Posted By sailtexas186548

I had a tiny hole rusted into a timing cover…...

I had a tiny hole rusted into a timing cover… paint chip on the outside and rusted through just in one tiny spot. the rest look perfect. Could happen on an oil pan too (if steel).

chased my tail...
10-17-2022, 07:57 PM
Replies: 30
Views: 3,331
Posted By sailtexas186548

bought and “restored” when I was 13 or 14, kept...

bought and “restored” when I was 13 or 14, kept it under a cover in the garage for the last 20 years, finally pulled it out and shined her up last spring. Another round of polishing and a few missing...
08-09-2022, 07:36 AM
Replies: 31
Views: 9,563
Posted By sailtexas186548

this is basically a “crash pump” that larger...

this is basically a “crash pump” that larger yachts run. Even better is to put a T fitting between the sea intake shutoff ball valve and the raw water pump (which side of the strainer is a risk,...
05-16-2022, 06:32 AM
Replies: 20
Views: 2,821
Posted By sailtexas186548

A Plane ticket and hotel for the night is cheap...

A Plane ticket and hotel for the night is cheap insurance
Forum: Scarab
02-28-2022, 08:32 PM
Replies: 17
Views: 5,090
Posted By sailtexas186548

Love it. I remember seeing a Vice boat in the...

Love it. I remember seeing a Vice boat in the lazy bend canal, was that yours?
12-21-2021, 10:43 PM
Replies: 7
Views: 2,589
Posted By sailtexas186548

Saltwater? hagarty told me my 30’ was too...

Saltwater?

hagarty told me my 30’ was too big for their program
Forum: Scarab
12-17-2021, 12:28 PM
Replies: 1,593
Views: 702,333
Posted By sailtexas186548

One of the top builds on OSO in recent history....

One of the top builds on OSO in recent history. No reason to rush but I’m looking forward to the next update!
Forum: General Q & A
11-27-2021, 08:55 AM
Replies: 18
Views: 3,206
Posted By sailtexas186548

My timing cover had a hole (rust) just under the...

My timing cover had a hole (rust) just under the seal that did t go away after several seal changes. I would pull the cover
09-14-2021, 05:22 PM
Replies: 128
Views: 23,509
Posted By sailtexas186548

Hagerty won’t touch something over 28’ and 20+...

Hagerty won’t touch something over 28’ and 20+ years old. That’s the cut off on a lot of insurers. They offered me boat coverage after insuring some of my cars and promptly said “no” when they found...
09-03-2021, 07:37 PM
Replies: 128
Views: 23,509
Posted By sailtexas186548

Hopefully not to the Middle East never to be seen...

Hopefully not to the Middle East never to be seen again
07-27-2021, 09:28 PM
Replies: 20
Views: 2,218
Posted By sailtexas186548

I think it’s great, the fishing boat guys are...

I think it’s great, the fishing boat guys are gonna put a hurting on everybody in the enduro races
Forum: Cigarette
07-10-2021, 08:06 AM
Replies: 55
Views: 9,762
Posted By sailtexas186548

Hard to believe bad gas damaged a valve like that...

Hard to believe bad gas damaged a valve like that unless all of the pistons show knock damage also, what does the knock sensor data show? That was probably a flawed valve IMO
06-04-2021, 09:28 PM
Replies: 20
Views: 3,971
Posted By sailtexas186548

I used flexible LED strips from PlashLights on my...

I used flexible LED strips from PlashLights on my fishing boat trailer, much higher quality than the cheap eBay strips. They come in red, blue, green, and white, or RGB which requires the Bluetooth...
Forum: General Q & A
06-01-2021, 05:49 PM
Replies: 16
Views: 2,285
Posted By sailtexas186548

the ME is a ceramic foam, it’s basically sanding...

the ME is a ceramic foam, it’s basically sanding with fine sandpaper. I would be careful using that on vinyls, it probably “cleans” by taking off the top layer of the material
Forum: General Q & A
05-19-2021, 05:46 PM
Replies: 31
Views: 9,396
Posted By sailtexas186548

I use an oil extractor (dedicated to antifreeze)...

I use an oil extractor (dedicated to antifreeze) to suck the coolant level way down before I remove the intake or heads, I keep the coolant in a 5 gallon bucket to reuse. My block drains are too hard...
05-10-2021, 09:21 PM
Replies: 29
Views: 7,710
Posted By sailtexas186548

While no response isn’t great, taking in your...

While no response isn’t great, taking in your props knowing they can’t get to them anytime soon is worse. It’s a tough world right now
05-03-2021, 05:36 PM
Replies: 1,498
Views: 550,573
Posted By sailtexas186548

I don't like the slop in my DBL Carden (BW 72x w/...

I don't like the slop in my DBL Carden (BW 72x w/ 1.5 ratio to 1:1 Arneson 1720 (ASD-6) direct drive) and have been looking into 934 CVs. My plan is basically custom machine a flange that bolts to...
04-13-2021, 09:31 PM
Replies: 103
Views: 17,862
Posted By sailtexas186548

Yes having something to run around in when you...

Yes having something to run around in when you get sick of grinding fiberglass really does ease the pain!
Forum: General Q & A
03-20-2021, 08:18 AM
Replies: 76
Views: 15,244
Posted By sailtexas186548

I’ll be extremely reluctant to continue using...

I’ll be extremely reluctant to continue using bolts in your situation, I would make the switch the studs now before you damage the block. If I am buying fasteners I always make the switch to studs.
...
Showing results 1 to 25 of 52
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.