Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: hypforlife32
Showing results 1 to 8 of 8
Search took 0.00 seconds.
Forum: Electronics
06-04-2023, 05:34 PM
Replies: 13
Views: 1,659
Posted By hypforlife32

MEfi 3 SCORPION 377 FACTORY TUNE FILE

Does anyone have a factory tune file for this ? I think mine have been messed with at some point in ownership. Thanks.
Forum: Electronics
08-31-2022, 10:14 AM
Replies: 3
Views: 865
Posted By hypforlife32

I called and they where pretty helpful. nothing...

I called and they where pretty helpful. nothing wrong with slightly extra power i guess. lol
06-25-2022, 09:52 AM
Replies: 18
Views: 1,300
Posted By hypforlife32

UPDATE: filled with fresh 93 and still have the...

UPDATE: filled with fresh 93 and still have the same issue. 30 percent throttle to hot start. if you run boat and turn the boat off. it starts back up immediately and runs great. even after sitting...
06-20-2022, 10:55 AM
Replies: 18
Views: 1,300
Posted By hypforlife32

Well im pretty confident i found my issue, ill...

Well im pretty confident i found my issue, ill attach a picture below. the right two where front the filters on the boat. the left is fresh 93. the right two bottles hardly had a fuel smell and when...
Forum: General Q & A
08-09-2021, 10:18 AM
Replies: 30
Views: 3,153
Posted By hypforlife32

before the other engine had a miss it was doing...

before the other engine had a miss it was doing 52 at 3400 rpm on the gps

FIXED! : IAC was not moving. had a bad connection with one of the wire. went right into service mode now and timing set!...
Forum: General Q & A
08-06-2021, 10:02 AM
Replies: 30
Views: 3,153
Posted By hypforlife32

by closed down you mean the plunger is fully...

by closed down you mean the plunger is fully extended and seated correct?
Forum: General Q & A
08-06-2021, 09:20 AM
Replies: 30
Views: 3,153
Posted By hypforlife32

haha, It happens, im so close to ripping in the...

haha, It happens, im so close to ripping in the water but this dang issue is hanging me up.
Forum: General Q & A
06-08-2021, 06:46 PM
Replies: 16
Views: 3,728
Posted By hypforlife32

yes. Had the cam spun on a cam machine.

yes. Had the cam spun on a cam machine.
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.