Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: j272
Showing results 1 to 24 of 24
Search took 0.01 seconds.
07-21-2023, 06:47 AM
Replies: 8
Views: 672
Posted By j272

I have seen these filters on the carb inlet...

I have seen these filters on the carb inlet clogged.often ignored
07-18-2023, 06:48 AM
Replies: 8
Views: 672
Posted By j272

check filter at carb fuel inlet

check filter at carb fuel inlet
Forum: Formula
07-13-2023, 05:52 AM
Replies: 1
Views: 540
Posted By j272

Formula 272 sr1performance report

Here it is
https://cimg1.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/740x768/_272_spec_guide_88_3e2651f33ca9f233d4225642b17d4d045052fbfb.jpg
Report
I had the 320 efi motors with bravo and emi...
Forum: Formula
05-24-2023, 04:50 AM
Replies: 3
Views: 739
Posted By j272

what a shame.

what a shame.
Forum: Formula
05-11-2023, 08:49 AM
Replies: 2
Views: 492
Posted By j272

I had 1 ...

I had 1
https://cimg7.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/2000x1130/imag3046_3da14b00ae92ff29f14c7406ffebc4db9f2d791c.jpg
1988
05-09-2023, 10:14 AM
Replies: 3
Views: 400
Posted By j272

They replied to my email and they are sending me...

They replied to my email and they are sending me new ones!
05-08-2023, 04:20 PM
Replies: 13
Views: 1,940
Posted By j272

don't drink till your done

don't drink till your done
04-18-2023, 03:24 PM
Replies: 4
Views: 1,196
Posted By j272

normal

normal
02-06-2023, 07:20 AM
Replies: 79
Views: 20,340
Posted By j272

Besides installing at least a dozen over the...

Besides installing at least a dozen over the years for customers, I had one on my own boat(sold).
It was a 22 f3ls 22' formula with a 260 hp mercruiser. The original alpha drive broke a tooth in the...
Forum: Formula
01-19-2023, 07:23 AM
Replies: 16
Views: 1,943
Posted By j272

I had a 272 sr1 1988 with twin factory 320 efi...

I had a 272 sr1 1988 with twin factory 320 efi 5.7 small blocks and bravo drives 1.5 ratio. It was faster than the 330 big block equipped ones. by about 5mph. And it was much quicker. I attribute...
Forum: Formula
11-02-2022, 04:36 AM
Replies: 21
Views: 2,628
Posted By j272

Yes thats sounds good. I found an online company...

Yes thats sounds good. I found an online company that has that correct font 'Bank gothic" that can make it pretty close to original. thanks for the advice.
Forum: General Q & A
10-28-2022, 05:55 AM
Replies: 46
Views: 7,356
Posted By j272

Thumbs up i have limited experience with roller rockers but...

i have limited experience with roller rockers but i would think steel is the way to go.
nice engines!
Forum: General Q & A
10-27-2022, 06:54 AM
Replies: 32
Views: 5,115
Posted By j272

Ive had 4 formulas. I think the sr1 hull is solid...

Ive had 4 formulas. I think the sr1 hull is solid wave slicer. Very predictable and super dry, doesn't have that hollow sound when crashing through the waves like some other boats. None of my...
Forum: General Q & A
10-07-2022, 09:43 AM
Replies: 11
Views: 1,224
Posted By j272

Thats looking a little rough. I would put a new...

Thats looking a little rough. I would put a new one in, also a new bilge pump and starter.
Forum: Formula
08-25-2022, 05:26 PM
Replies: 11
Views: 1,967
Posted By j272

yes I sold it 1st person to look at it bought it

yes I sold it 1st person to look at it bought it
Forum: Formula
08-24-2022, 07:04 AM
Replies: 11
Views: 1,967
Posted By j272

yeah. It's a good boat for family and friends....

yeah. It's a good boat for family and friends. It's got the 5.7 efi motors. Goes 58 mph on dash speedo. Fast enough. Kinda
Forum: Formula
08-24-2022, 06:01 AM
Replies: 11
Views: 1,967
Posted By j272

New to me. 3rd formula

https://cimg1.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/2000x1504/20220814_103854_f1750026e929a1b4bfba2c05bda19741b6cf741b.jpg
Forum: Formula
08-05-2022, 03:44 PM
Replies: 7
Views: 833
Posted By j272

just bought 280br without the arch. Problem solved

just bought 280br without the arch. Problem solved
08-05-2022, 03:40 PM
Replies: 24
Views: 5,896
Posted By j272

the two engine mounts on each side that mounts to...

the two engine mounts on each side that mounts to the stringers have slots in them for adjusting the twist. Loosen them up and move it to where you need it then tighten back down. I have over 35...
Forum: General Q & A
07-01-2022, 12:05 PM
Replies: 26
Views: 2,760
Posted By j272

https://cimg4.ibsrv.net/gimg/www.offshoreonly.com-...

https://cimg4.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/2000x971/20210501_124745_bb32eb1ae9979e7a74e42243c48cf7fd103c7962.jpg
Forum: Formula
06-27-2022, 06:44 AM
Replies: 9
Views: 1,477
Posted By j272

$172 delivered

https://cimg1.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/756x1008/resized_20220625_153153_222ad74f271efbbe22dc06ed05fe44a36f0b4012.jpeg
Forum: Formula
06-22-2022, 10:24 AM
Replies: 9
Views: 1,477
Posted By j272

i ended up getting one! 8 ft long gray 4 bow ...

i ended up getting one! 8 ft long gray 4 bow
https://cimg7.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/1008x756/resized_20220619_110837_a0f161b8ee2a874dfef0a71e896277db45a5d268.jpeg
Forum: Formula
06-06-2022, 05:22 PM
Replies: 90
Views: 31,606
Posted By j272

mint

mint
Forum: General Q & A
05-03-2022, 09:24 AM
Replies: 10
Views: 5,058
Posted By j272

1. pull risers and check, 2. then pull intake...

1. pull risers and check,
2. then pull intake manifold and check for cracks in lifter valley. and check intake gasket.
3. cylinder heads rust out to a point where they eat into the head gasket...
Showing results 1 to 24 of 24


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.