Offshoreonly.com - Search Results

Search: Posts Made By: Falcon

Showing results 1 to 7 of 7
Search took 0.01 seconds.

Forum: General Q & A

03-07-2023, 08:57 AM

Replies: 12

Technique for shifting without engine running?

Views: 1,310

Posted By Falcon

Sometimes you can hold the shift lever just far...

Sometimes you can hold the shift lever just far enough to get off the in-gear contact switch and use the starter. As the starter turns, it will likely pop out of gear, but be ready, it may go right...

Forum: Trucks, Trailers and Transportation

11-06-2022, 10:11 AM

Replies: 41

Diesel Shortage Coming........

Views: 5,853

Posted By Falcon

See this if you want to actually understand the...

See this if you want to actually understand the issues:
https://www.youtube.com/watch?v=7a8YsbtH0sc

Forum: General Boating Discussion

10-24-2022, 06:37 PM

Replies: 16

500efi and 700sci height differnce

Views: 1,594

Posted By Falcon

I don't seem to have the dimensions on the...

I don't seem to have the dimensions on the 500efi, but I did find some info on a 525. On the 525, the top of the sweeper headers are the highest point at about 23.4" up from crank center. On the...

Forum: Drives and Lower Units

09-16-2022, 10:08 AM

Replies: 30

Bravo 1 increase negative trim cutting trim rods

Views: 3,472

Posted By Falcon

You should also allow a "little" extra room for...

You should also allow a "little" extra room for the compression of the rubber mounts when with load in forward.

Forum: General Q & A

08-24-2022, 08:39 PM

Replies: 5

Building Tails... clearance between inner and outer pipes?

Views: 808

Posted By Falcon

Stainless tubing used for tailpipes is usually...

Stainless tubing used for tailpipes is usually measured by outside diameter and the inner tube is usually 1/2" smaller than the outer; 4.00" outside diameter outer tube, 3.50" outside diameter inner...

Forum: General Q & A

06-12-2022, 10:32 PM

Replies: 2

Mercury 700 sci adj shift interrupter?

Views: 735

Posted By Falcon

It's been a while but here goes: There are 2...

It's been a while but here goes:
There are 2 switches on the shift bracket, one is the neutral position switch (the switch under the shift lever on the bracket) which will not let it start in-gear,...

Forum: General Q & A

07-02-2006, 10:36 PM

Replies: 13

Hydraulic steering installation question/problem?

Views: 4,731

Posted By Falcon

Re: Hydraulic steering installation question/problem?

The problem with going up or down from center is that the cylinders will change length more with trim. Let's say you mount above center, when you trim up, both cylinders have to compress at the same...

Showing results 1 to 7 of 7