Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Tinkerer
Showing results 1 to 6 of 6
Search took 0.01 seconds.
Forum: Do It Yourself, Boating on a Budget
07-22-2020, 09:45 PM
Replies: 20
Views: 3,690
Posted By Tinkerer

If you can't get the drive on or off with LITTLE...

If you can't get the drive on or off with LITTLE effort the engine is not aligned properly.
The tool needs to slide in and out with two fingers.
You should never have to force the drive on.
it...
Forum: Do It Yourself, Boating on a Budget
06-21-2020, 07:36 AM
Replies: 8
Views: 719
Posted By Tinkerer

Like he said 4800 RPM is perfect for that engine....

Like he said 4800 RPM is perfect for that engine.
Sounds to me like the 23 pitch is perfect also.
Word of advise...
DONT put any more money into that 454.
Find yourself a good 502 MAG carbed...
Forum: Photo Contest Forum
06-19-2020, 04:52 PM
Replies: 58
Views: 31,442
Posted By Tinkerer

https://cimg0.ibsrv.net/gimg/www.offshoreonly.com-...

https://cimg0.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/1120x2000/img_20160724_104053486_4cdc96effe976d7162ca43bc841ebf015c2c4c13.jpg
Gracie All 4 lbs 14 ounces of her.
Forum: General Boating Discussion
05-06-2017, 08:06 PM
Replies: 21
Views: 24,229
Posted By Tinkerer

When I had turn downs they ended 6 inches below...

When I had turn downs they ended 6 inches below the water line in gear at idle. To stop the loud pulses I drilled 1/4 inch holes about 2 inches wide and three inches tall from the bottom of the pipes...
Forum: General Q & A
07-04-2003, 08:38 PM
Replies: 2
Views: 16,489
Posted By Tinkerer

What I do and it is very easy. I install the...

What I do and it is very easy. I install the cylinders but not the rod at the eye of the cylinders. Put a rag under the cylinder to keep it off the drive and just trim it in and out a whole bunch of...
Forum: General Q & A
01-20-2002, 03:32 PM
Replies: 11
Views: 4,170
Posted By Tinkerer

Post Most of my time is spent crusing at 3000 to 3500...

Most of my time is spent crusing at 3000 to 3500 rpm. and believe me the exhaust stays closed because I can hear it when the flappers arn't closed all the way. This boat is LOUD.
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.