Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: Griff
Showing results 1 to 25 of 500
Search took 0.03 seconds.
Forum: General Q & A
04-22-2024, 01:30 AM
Replies: 17
Views: 588
Posted By Griff

Being that it is an intermittent, I'd say it is a...

Being that it is an intermittent, I'd say it is a problem in the wiring harness.
You need to hook it to Rinda scan tool or better yet, the laptop diacom and get live data when its actually having...
Forum: Cigarette
04-19-2024, 01:05 AM
Replies: 224
Views: 41,051
Posted By Griff

Can't believe you actually sold...

Can't believe you actually sold it:eekdrop::eekdrop::eekdrop:
Forum: General Q & A
04-18-2024, 01:03 AM
Replies: 15
Views: 617
Posted By Griff

I ran Rapid Fires #1's a long time ago. The only...

I ran Rapid Fires #1's a long time ago. The only difference from them and MR43's was that they did not foul out at idle on my engine.
Forum: General Q & A
04-18-2024, 12:57 AM
Replies: 15
Views: 597
Posted By Griff

If the hatch ram is not on a relay, you can just...

If the hatch ram is not on a relay, you can just apply 12 Volts to the back of the hatch switch
04-17-2024, 01:39 AM
Replies: 1
Views: 180
Posted By Griff

Must host it on another video sharing site and...

Must host it on another video sharing site and post link. Posting the link will automatically display the video. No way no directly upload videos on OSO.
04-15-2024, 12:32 AM
Replies: 16
Views: 1,466
Posted By Griff

Trim the drive so the propshaft is parallel to...

Trim the drive so the propshaft is parallel to the bottom and then measure how deep the propshaft is below the hull.
04-10-2024, 12:47 AM
Replies: 11
Views: 910
Posted By Griff

Technically you are still the give way boat, but...

Technically you are still the give way boat, but I know when I come out of coves, I always yield to the main channel traffic and most good boaters do the same.
Forum: Prop Talk
04-08-2024, 10:51 PM
Replies: 14
Views: 686
Posted By Griff

Your props are spinning out. The LH prop is port...

Your props are spinning out. The LH prop is port and RH prop is on starboard.

As far as drive showers, just get the new style Simreks and you don't need to drill anything SIMREK Multiport Drive...
04-08-2024, 10:19 PM
Replies: 16
Views: 1,265
Posted By Griff

How many people and how big of boat?? A...

How many people and how big of boat??

A condo will be quite a bit less $$ than a house and much easier to find what you are looking for.
04-08-2024, 10:17 PM
Replies: 16
Views: 1,265
Posted By Griff

I assume he means Camden on the Lake aka H...

I assume he means Camden on the Lake aka H Toad's???

Coconuts is 7 miles away by water, but as much as an hour away by car.
Forum: Cigarette
04-08-2024, 12:06 AM
Replies: 167
Views: 26,140
Posted By Griff

Nice numbers!!!! I would like to see the what the...

Nice numbers!!!! I would like to see the what the AFR's are. They definitely don't need 1100cfm carbs. A well tuned 850cfm should be plenty.
I would prop for around 5600WOT. Fully dressed in the...
Forum: Prop Talk
04-07-2024, 11:36 PM
Replies: 14
Views: 686
Posted By Griff

No right or wrong way to spin them. There may be...

No right or wrong way to spin them. There may be some performance advantage to spinning in, especially with 5 blades. More blades = more stern lift. Spinning in creates more bow lift, so that will...
04-03-2024, 11:55 PM
Replies: 15
Views: 1,080
Posted By Griff

Not to be confused with this Griff.....LOL:D

Not to be confused with this Griff.....LOL:D
03-30-2024, 11:13 PM
Replies: 11
Views: 1,453
Posted By Griff

If you make it down and need a place to stay, I...

If you make it down and need a place to stay, I have lots of friends in my condo complex with 1br/1ba lakefront rental condos that are priced lower than most regular hotels. Located about 10 mins...
03-29-2024, 09:40 PM
Replies: 42
Views: 1,914
Posted By Griff

Just jack the front of the pallet up and put some...

Just jack the front of the pallet up and put some blocks or 2x4's under it
03-29-2024, 09:35 PM
Replies: 9
Views: 459
Posted By Griff

If a boat worth 16k needs stringer or transom...

If a boat worth 16k needs stringer or transom repair, you might as well just part it out. The chances of a 1987 Wellcraft not having some moisture issues is slim at best. Most likely the floor would...
03-29-2024, 09:23 PM
Replies: 11
Views: 1,453
Posted By Griff

As in one of the actual marinas they own or are...

As in one of the actual marinas they own or are you buying a boat or????
Ed Champion (eddie on OSO) is top notch and handles most of their performance boat sales. Known him for 20+ years
Forum: General Q & A
03-29-2024, 12:23 AM
Replies: 21
Views: 930
Posted By Griff

Diagram Thermostat Housing...

Diagram
Thermostat Housing (mercruiserparts.com) (https://www.mercruiserparts.com/bam/subassembly/31350/2522/120)
03-29-2024, 12:17 AM
03-27-2024, 05:42 PM
Replies: 8
Views: 356
Posted By Griff

Pull the plug out of the upper tailpipe and run...

Pull the plug out of the upper tailpipe and run the hose that ran to your manifold riser there....
Forum: General Q & A
03-27-2024, 01:23 AM
Replies: 21
Views: 930
Posted By Griff

Do you mean that you have ZERO psi of water...

Do you mean that you have ZERO psi of water pressure???
That is nearly impossible if you have some flow. My 525SC had around 1-3psi at idle and 20psi at WOT
First thing to do it verify that the...
Forum: Midwest
03-26-2024, 12:37 PM
Replies: 108
Views: 14,678
Posted By Griff

Lots of people build a "V" at the front of their...

Lots of people build a "V" at the front of their slips. Some people with wider slips will have the lift companies build a walkway around the boat that is attached to the lift as well. Many people...
03-21-2024, 11:14 PM
Replies: 12
Views: 924
Posted By Griff

Most likely, the file sizes of the pics you are...

Most likely, the file sizes of the pics you are trying to upload are too large.
Forum: General Q & A
03-21-2024, 11:03 PM
Replies: 12
Views: 639
Posted By Griff

I would just get rid of the entire VST system....

I would just get rid of the entire VST system. Use one electric pump with a pressure regulator and then run a return line back to the tank. Use a relay to run the new electric pump.
Forum: General Q & A
03-18-2024, 10:28 PM
Replies: 72
Views: 3,946
Posted By Griff

Not permanent

Not permanent
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.