Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: TomR
Showing results 1 to 18 of 18
Search took 0.01 seconds.
Forum: Swap Shop
05-25-2023, 05:08 PM
Replies: 2
Views: 445
Posted By TomR

Pair of 34" Pitch Bravo 1s

I have a pair of Bravo 1, 34" pitch props in good condition. Original, have not been labbed. Asking $1,100.00 plus the ride. PM me or txt 5082373326 for pics
Forum: Northeast US
07-28-2022, 06:36 PM
Replies: 25
Views: 6,334
Posted By TomR

We visited Seneca Lake on the 15th-17th for a...

We visited Seneca Lake on the 15th-17th for a couple of days of boating before heading to Thousand Islands, loved it! We stayed at the Seneca Lake Resorts/ Sampson State Park. That Saturday was our...
05-24-2022, 05:56 AM
Replies: 141
Views: 22,576
Posted By TomR

Congrats! Nice looking Boat!!

Congrats! Nice looking Boat!!
Forum: Fountain
05-10-2022, 06:45 AM
Replies: 17
Views: 7,156
Posted By TomR

That is considered. There is a thin vinyl washer...

That is considered. There is a thin vinyl washer that fits under the pointer.
Forum: Swap Shop
04-26-2022, 01:04 PM
Replies: 0
Views: 1,630
Posted By TomR

Parts Available I Don't Need

1) Fluid Damper for BBC, ext balance. $150.00

2) 2 Mercruiser oil filter/cooler bypasses for Gen IV BBC $50.00 each

3) pair of wind deflectors to fit on top of Fountain windscreen. $200.00
...
Forum: Northeast US
10-04-2021, 06:02 PM
Replies: 44
Views: 12,220
Posted By TomR

Thank you Chris for putting the run together! ...

Thank you Chris for putting the run together! Karen and I had great weekend.
07-22-2021, 06:13 AM
Replies: 43
Views: 26,682
Posted By TomR

Hard to believe that was 37yrs ago!!

Hard to believe that was 37yrs ago!!
Forum: Fountain
05-19-2021, 06:55 PM
Replies: 2
Views: 515
Posted By TomR

It's 12 volts, direct to battery. It's for the...

It's 12 volts, direct to battery. It's for the automatic bilge pump.
Forum: Formula
03-29-2021, 06:12 AM
Replies: 12
Views: 1,922
Posted By TomR

Tom, If you look on the intake side of the fuel...

Tom,
If you look on the intake side of the fuel pump there may well be a screen.
Forum: Formula
03-28-2021, 05:48 PM
Replies: 12
Views: 1,922
Posted By TomR

Hi Tom, I run Aeromotive electric pumps in...

Hi Tom,

I run Aeromotive electric pumps in my current boat that are mounted on the stringers in line with the outside of each engine that are just about level to the tops of the tanks. I do run an...
03-12-2021, 06:04 AM
Replies: 63
Views: 16,516
Posted By TomR

Using the kill switch lanyard is just common...

Using the kill switch lanyard is just common sense. Unfortunately not everyone does and then we have an avoidable tragedy that can affect others! Laws are not always some plot by the "Deep State" to...
03-05-2021, 02:07 PM
Replies: 33
Views: 5,951
Posted By TomR

Stirring the Pot Randy!!

Stirring the Pot Randy!!
Forum: Fountain
02-28-2021, 12:33 PM
Replies: 8
Views: 1,362
Posted By TomR

I have one. They work great! ...

I have one. They work great! https://www.overtons.com/anchorshade-iii-6-x-6-red-307994_RED.html?gclsrc=aw.ds
02-28-2021, 11:11 AM
Replies: 918
Views: 154,378
Posted By TomR

Welcome to the board Markus, wherever you're...

Welcome to the board Markus, wherever you're from!

Not all of us in the US view things that are only supported by alternative and skewed facts. Some of us try to drill down a little deeper...
02-28-2021, 08:53 AM
Replies: 10
Views: 3,407
Posted By TomR

Wag's Engineering made a nice Billet top cap with...

Wag's Engineering made a nice Billet top cap with an integrated shower. I had them on my two previous boats. I tried to get them for my current boat but it doesn't appear they are making them any...
Forum: General Q & A
10-06-2020, 07:35 PM
Replies: 10
Views: 4,879
Posted By TomR

Carefully put some heat to the housing! I would...

Carefully put some heat to the housing! I would use two MAP gas torches, one on each side, heat it up a bit and then take a couple of good 3" putty knives and tap one in on each side while applying...
Forum: General Q & A
05-08-2020, 05:57 AM
Replies: 3
Views: 440
Posted By TomR

If you have "GOOD" access to under the front of...

If you have "GOOD" access to under the front of engine you can loosen the oil pan bolts (more towards the front less further back) & GENTLY pry down on the front corners of the pan. This will allow...
05-08-2020, 05:44 AM
Replies: 13
Views: 1,202
Posted By TomR

I have a Merc one from a 525SC, PM me if...

I have a Merc one from a 525SC, PM me if interested
Showing results 1 to 18 of 18


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.