Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: Stitch King
Showing results 1 to 25 of 34
Search took 0.07 seconds.
Forum: Cobalt
03-18-2024, 12:48 PM
Replies: 290
Views: 282,711
Posted By DMS_ATX

No inline fuel filters on stringers install on my...

No inline fuel filters on stringers install on my boat. Might be an auto parts special, likely easiest to remove and take with you to a store and find replacements. pretty sure the OEM ones are fuel...
Forum: Cobalt
03-15-2024, 08:03 PM
Replies: 290
Views: 282,711
Posted By DMS_ATX

Sitch Kind, a lot of the 496 boat got built with...

Sitch Kind, a lot of the 496 boat got built with B3s, not B1 ones like the 525 boats. mine has 525s with 28P 4 blade B1....
Forum: General Boating Discussion
01-01-2024, 07:26 AM
Replies: 11
Views: 1,150
Posted By B38

Easy, pull exhaust manifold and riser off....

Easy, pull exhaust manifold and riser off. Replace starter and check exhaust for leaks.
Not that bad. Just do it. Or pay $$$$$
Forum: General Boating Discussion
12-28-2023, 10:07 AM
Replies: 11
Views: 1,150
Posted By Helmwurst

^^^ Find a skinny tech with 8' arms!

^^^ Find a skinny tech with 8' arms!
Forum: Cobalt
11-27-2023, 08:49 AM
Replies: 40
Views: 6,686
Posted By Maritime_Eng

As of right now the boat is ready for paint/...

As of right now the boat is ready for paint/ interior and rigging but need to sell my Center Console boat to pay for this activity. I will be using 3 Bob's Jackplates with 10" setback when I install...
Forum: Cobalt
10-23-2023, 06:17 PM
Replies: 290
Views: 282,711
Posted By Quinlan

Looks Great!

Looks Great!
Forum: Drives and Lower Units
09-14-2023, 10:49 AM
Replies: 92
Views: 22,862
Posted By Wildman_grafix

Any Updates?

Any Updates?
Forum: General Q & A
09-10-2023, 07:40 PM
Replies: 12
Views: 888
Posted By PA.WOODCHUCK

If you have cool fuel 3 paint inside can peel off...

If you have cool fuel 3 paint inside can peel off and cause havoc
Forum: General Q & A
09-10-2023, 05:36 PM
Replies: 12
Views: 888
Posted By techman

Failures? None if you take care of them. ...

Failures? None if you take care of them.

Common problem/maintenance areas perhaps? IAC, Sensors, Coil Packs. Water Pump housings.

Use them and maintain them and you're good to go.
Forum: Cobalt
08-23-2023, 05:07 AM
Replies: 290
Views: 282,711
Posted By Quinlan

https://cimg6.ibsrv.net/gimg/www.offshoreonly.com-...

https://cimg6.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/640x480/mooneys_4c36205c7e3eeb2dd93533a36b13ac3970e3f4b8.jpg
Another fine day.
Forum: Cobalt
08-01-2023, 07:27 AM
Replies: 290
Views: 282,711
Posted By Wildman_grafix

I have been out that inlet in the same...

I have been out that inlet in the same conditions, those waves are straight up. Coming back in was fun though. :)

Surprised on the trailer weight, my steal Myco for the little 32 is 1800lbs. I...
Forum: Cobalt
08-01-2023, 05:26 AM
Replies: 290
Views: 282,711
Posted By Quinlan

I am learning to Drive it. It takes the water...

I am learning to Drive it. It takes the water Ok. Not like the Gun for sure. little rougher because it is so heavy, I feel as where the Gun would skip across the tops.
It rides MUCH better now...
Forum: Cobalt
07-31-2023, 08:27 AM
Replies: 290
Views: 282,711
Posted By Helmwurst

About the same or less weight than a new center...

About the same or less weight than a new center console with trips or quads, right?
Forum: Cobalt
07-31-2023, 05:29 AM
Replies: 290
Views: 282,711
Posted By Quinlan

https://cimg7.ibsrv.net/gimg/www.offshoreonly.com-...

https://cimg7.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/640x480/cobalt_7_5abe57e35ca61b04502ccb9d792748bf1e2fbc29.jpg...
Forum: Drives and Lower Units
07-24-2023, 12:25 PM
Replies: 92
Views: 22,862
Posted By boatnt

yep I hear you, I'm not a cheerleader or a ...

yep I hear you, I'm not a cheerleader or a spokesman for SEI, I chose to go this route because of the price point and being new, for 3K these days you're buying a used 20 year old Bravo that's been...
Forum: Drives and Lower Units
07-24-2023, 10:16 AM
Replies: 92
Views: 22,862
Posted By boatnt

yes I used the original imco steering caps,

yes I used the original imco steering caps,
Forum: Cobalt
06-24-2023, 05:00 PM
Replies: 290
Views: 282,711
Posted By Maritime_Eng

I used a 2" hole saw and drilled holes on that...

I used a 2" hole saw and drilled holes on that stringer right next to the trim pump and on each side of all 4 stringers to allow everything to drain down to the bildge pumps.
Forum: Cobalt
06-24-2023, 03:13 PM
Replies: 290
Views: 282,711
Posted By speicher lane

Stitch King - Just posting your pic so later on...

Stitch King - Just posting your pic so later on when the link is dead, anyone searching for a similar issue can see what you were referring to

...
Forum: Cobalt
06-16-2023, 01:51 PM
Replies: 290
Views: 282,711
Posted By Maritime_Eng

https://cimg9.ibsrv.net/gimg/www.offshoreonly.com-...

https://cimg9.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/2000x901/20230616_144813_43bc27a6378c03e842190e9c9635efa767b5935f.jpg
Here is mine. My winch could be lower by 4 or 5 inches.
Forum: Cobalt
06-16-2023, 10:27 AM
Replies: 290
Views: 282,711
Posted By Holy Smokes

Can't post a pic, but the forward cradle should...

Can't post a pic, but the forward cradle should catch the keel well below the bow eye & trailer winch. Proper setup will have cradle and winch stand as two separate attachments.
Forum: Cobalt
06-04-2023, 07:57 AM
Replies: 290
Views: 282,711
Posted By Maritime_Eng

You are correct, there are no holes in the...

You are correct, there are no holes in the stringers, which is weird because the stringers are actually hallow. Once the motors were removed I used a hole saw and add drain holes.
Forum: Cobalt
06-02-2023, 07:49 AM
Replies: 290
Views: 282,711
Posted By Maritime_Eng

If anyone has any questions about how the 343...

If anyone has any questions about how the 343 cobalt is built let me know. I am about half way thru converting the boat from inboards to outboards and from a closed deck to open bow. I have cut or...
Forum: Cobalt
05-30-2023, 08:29 AM
Replies: 290
Views: 282,711
Posted By pasquesi

These guys built a tower for my Glacier Bay cat...

These guys built a tower for my Glacier Bay cat in 2000. They did a really nice job.

https://www.atlantictowers.com/custom-towers.php
Forum: Cobalt
05-22-2023, 04:59 PM
Replies: 290
Views: 282,711
Posted By Quinlan

Hey Stich- if you do the tower I would be Very...

Hey Stich- if you do the tower I would be Very much interested in one also. I have someone working on a Bimini but last time they did anything for me it was 2 + years :picard1: and FWIW i be 59...
Forum: Cobalt
05-08-2023, 07:23 AM
Replies: 290
Views: 282,711
Posted By bulletbob

Congrats Stitch King on the purchase. I remember...

Congrats Stitch King on the purchase. I remember when that boat came to lake Murray. The owner did take care of the boat. I remember it being immaculate.
Showing results 1 to 25 of 34
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.