Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: shunter2005
Showing results 1 to 25 of 52
Search took 0.23 seconds.
11-25-2023, 10:09 AM
Replies: 10
Views: 998
Posted By johnmiffco

i will be seeing the 32 this winter that was done...

i will be seeing the 32 this winter that was done in Dallas area
to check out their workmanship ,,,,
shop in conroe been there a long time,,,,but been a while since ive seen their work
but looking...
11-24-2023, 10:12 AM
Replies: 10
Views: 998
Posted By johnmiffco

ive seen the work on a couple boats from santa...

ive seen the work on a couple boats from santa cruz shop
and looked good,,,
have a skater bud by dallas that had his 32 interior done that just got back from a shop in dallas area
@ 1/2 the price...
Forum: General Q & A
07-24-2022, 06:54 PM
Replies: 17
Views: 2,244
Posted By bajaman

To me the numbers make sense; the same cylinders...

To me the numbers make sense; the same cylinders low on compression have the highest leakage...but it is entirely possible you have some crap stuck on the exhaust valve(s) on the low cylinders. Back...
05-06-2022, 12:31 AM
Replies: 7
Views: 953
Posted By Griff

You need something to connect your steering wheel...

You need something to connect your steering wheel to the hyd helm. Your old cable stuff will not work for that.
Forum: General Q & A
05-03-2022, 12:07 PM
Replies: 6
Views: 1,276
Posted By Griff

Imco's chart on page 70 will get you close...

Imco's chart on page 70 will get you close https://imcosteering.com/imco-catalog-2022-v5.pdf
10-16-2021, 12:53 PM
Replies: 22
Views: 3,305
Posted By Griff

That is your oil cooler that you circled. All you...

That is your oil cooler that you circled. All you need to is pull off the water hose and feel inside the end of the oil cooler with your fingers for any debris. It is only about a 2-3" deep before...
Forum: General Q & A
08-31-2021, 01:57 PM
Replies: 5
Views: 1,067
Posted By liberator221

Dui-c9055bk

Dui-c9055bk
08-27-2021, 07:19 PM
Replies: 20
Views: 4,356
Posted By Craney

I have that cam you can have it free you can call...

I have that cam you can have it free you can call me Brian 856-863-5635
07-27-2021, 04:20 PM
Replies: 20
Views: 4,356
Posted By 1Zoom

I installed the Hydrastar early last year as...

I installed the Hydrastar early last year as stated above even if you don't need the CAM converter it is worth getting it. I did not need it but installed it and it does not effect the system. I...
06-29-2021, 12:27 PM
Replies: 23
Views: 5,496
Posted By Griff

Before you start changing parts, figure out which...

Before you start changing parts, figure out which sensor is setting off the alarm.

All the wires for the alarm system are tan and blue. The alarm sensors are separate from the gauge sensors. The...
06-28-2021, 01:42 AM
Replies: 23
Views: 5,496
Posted By Griff

Very few things will set off the alarm on a...

Very few things will set off the alarm on a 502mpi. Low oil pressure, high water temp and drive lube.
My guess is your drive lube float is acting up. Merc gear lube turns to pudding like sludge in...
06-07-2021, 06:50 PM
Replies: 49
Views: 16,166
Posted By Padraig

Needed to bring the VR 1 to Buffalo NY area for...

Needed to bring the VR 1 to Buffalo NY area for some work. About 170 miles round trip. The EOH worked wonderfully. I did do a little fine tuning on the controller but I am extremely happy with...
Forum: General Q & A
06-04-2021, 06:23 AM
Replies: 8
Views: 1,246
Posted By Helmwurst

I did the IMCO setup (complete steering system)...

I did the IMCO setup (complete steering system) 10 years ago. It was easy to do, just took a few days. Never had an issue since, boat practically drives itself. Sold all the takeoff parts on here and...
04-28-2021, 03:37 PM
Replies: 3
Views: 1,536
Posted By Cory H

Performance Boat Candy is my favorite.

Performance Boat Candy is my favorite.
Forum: General Q & A
11-17-2020, 01:21 AM
Replies: 33
Views: 17,850
Posted By Griff

Why are you trying to pry the belt over the deep...

Why are you trying to pry the belt over the deep outside lip of the grooved alternator pulley instead of trying to slide it onto one of the pulleys that has a smooth side and contacts the flat side...
Forum: General Q & A
08-03-2020, 07:55 PM
Replies: 19
Views: 4,664
Posted By SR24Dave

Exotic Engine Development, has done extensive...

Exotic Engine Development, has done extensive work for many platforms for: American Air Racing,Calvo Motorsports, Eliminator Boats,
Moto Sports, Blue Thunder II, Teaque, and many other big boat...
Forum: General Q & A
08-02-2020, 02:03 PM
Replies: 19
Views: 4,664
Posted By SR24Dave

Will in Texas works for a shop that does very...

Will in Texas works for a shop that does very high end viper rebuilds 98% race applications with stupid power, turbo and SC motors and some marine motors aswell.
I will try to find the shop name...
06-16-2020, 08:39 PM
Replies: 22
Views: 5,559
Posted By SkiDoc

Update......did diagnostic test on the Carlisle...

Update......did diagnostic test on the Carlisle Hydrastar 14 yo unit and it is bad. I talked to the people at Hydrastar, who by the way are powerboaters and I am going to order a new unit from them....
06-13-2020, 06:52 AM
Replies: 22
Views: 5,559
Posted By SkiDoc

Picked up the boat and the brakes of course...

Picked up the boat and the brakes of course didn’t work. I tried to diagnose it at the boat ramp. The 7 way plug was real crusty so I replaced it and didnt help. I pulled the breakaway and the...
02-26-2020, 08:15 PM
Replies: 49
Views: 16,166
Posted By Wildman_grafix

I got all my stuff from Eastern marine.

I got all my stuff from Eastern marine.
Forum: Formula
07-29-2019, 10:47 PM
Replies: 33
Views: 7,182
Posted By TomZ

I use a Livorsi 80 MPH GPS speedo that receives...

I use a Livorsi 80 MPH GPS speedo that receives the GPS signal from my Lowrance chart plotter. The external antenna always had problems.
06-27-2019, 07:01 AM
Replies: 13
Views: 4,249
Posted By F14A water jet

Thanks...I assumed that the Hydrastar wiring was...

Thanks...I assumed that the Hydrastar wiring was not the issue because it worked with my Buddy's truck. That being said...maybe my trailer plug is not wired correctly or has a broken wire. I will...
Forum: General Q & A
02-26-2019, 09:41 AM
Replies: 4
Views: 1,422
Posted By Baja Rooster

I have one and it’s been great so far. Nice and...

I have one and it’s been great so far. Nice and simple set up. Just make sure you’ve got a large enough power wire going to it though.
Forum: Baja
01-29-2019, 03:25 PM
Replies: 9
Views: 3,865
Posted By ScottiG

I'll second the method Shunter outlined... This...

I'll second the method Shunter outlined... This method has been used for years by people that restore old electronics cases and toys. The method is not depreciating to the part like sanding, acetone...
07-13-2018, 01:45 PM
Replies: 9
Views: 2,562
Posted By F-2 Speedy

You also have to machine ( cut down the divider )...

You also have to machine ( cut down the divider ) the shorter housing flange makes it bottom out and won't seal, happened to me 502 mpi
Showing results 1 to 25 of 52
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.