Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: rokj
Showing results 1 to 6 of 6
Search took 0.07 seconds.
Forum: Electronics
08-16-2022, 10:51 AM
Replies: 9
Views: 1,085
Posted By DrFeelgood

Schrader valve location is perfectly acceptable...

Schrader valve location is perfectly acceptable for obtaining a fuel pressure reading, but a permanently installed sender typically requires removal of the core of the schrader valve.
08-06-2022, 04:24 PM
Replies: 24
Views: 6,091
Posted By tommymonza

If your chewin up couplers and having a problem ...

If your chewin up couplers and having a problem aligning I would take a hard look at your transoms condition.
08-05-2022, 03:40 PM
Replies: 24
Views: 6,091
Posted By j272

the two engine mounts on each side that mounts to...

the two engine mounts on each side that mounts to the stringers have slots in them for adjusting the twist. Loosen them up and move it to where you need it then tighten back down. I have over 35...
08-05-2022, 09:25 AM
Replies: 24
Views: 6,091
Posted By 87MirageIntruder

This might sound stupid but have you turned the...

This might sound stupid but have you turned the engine over by hand to see if that tube moves side to side?
04-11-2021, 02:50 PM
Replies: 21
Views: 5,856
Posted By boatnt

I think about 10-12 years ago

I think about 10-12 years ago
04-11-2021, 07:52 AM
Replies: 3
Views: 957
Posted By JaayTeee

805164 is the p/n for the 3/8 u bolt, what is the...

805164 is the p/n for the 3/8 u bolt, what is the # you got?
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.