Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: Jammer864
Showing results 1 to 12 of 12
Search took 0.09 seconds.
03-16-2022, 07:09 AM
Replies: 158
Views: 27,828
Posted By CPFITNESS

Verdict is in it was the carb! I wasn't able to...

Verdict is in it was the carb! I wasn't able to attend the last sea trial but mechanic reported back that she ran strong and idled proper. He did discover that the tach itself seems to be acting up....
Forum: General Q & A
09-16-2021, 07:44 AM
Replies: 8
Views: 1,157
Posted By outonsafari

https://cimg7.ibsrv.net/gimg/www.offshoreonly.com-...

https://cimg7.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/1920x1200/screenshot_20210916_082915_samsung_internet_b3019c0eec4b9be98b87960fc74cac201a9434ee.jpg

Get a piece of hose that fits the...
Forum: General Q & A
09-16-2021, 06:41 AM
Replies: 8
Views: 1,157
Posted By Inrecovery

I have one mint 525sc intake left. pm if needed...

I have one mint 525sc intake left. pm if needed i can dig it out.
Forum: General Q & A
09-15-2021, 09:00 PM
Replies: 8
Views: 1,157
Posted By Inrecovery

ok , i see the mech fuel pumps , so check that...

ok , i see the mech fuel pumps , so check that out, only takes a few mins and with new gear oil you wont wipe out the cam lobe in there, not sure what gen Stainless marine exhaust you have, but that...
Forum: General Q & A
09-15-2021, 08:53 PM
Replies: 8
Views: 1,157
Posted By Inrecovery

Im not sure i would run any water thru the motor...

Im not sure i would run any water thru the motor before checking the exhaust, unless your know its good, but you said it was from Florida. Feed the seawater pumps direct by running a hose to the...
Forum: General Q & A
05-03-2020, 12:59 PM
Replies: 12
Views: 3,074
Posted By Griff

You should be able to use either the front...

You should be able to use either the front location where the shrader valve is or the rear port plug on the fuel rail. The issue for both spots is having enough space for the sender. The front needs...
Forum: General Q & A
04-28-2020, 02:47 PM
Replies: 12
Views: 3,074
Posted By Revelocity

It's been about 20 years ago but I remember...

It's been about 20 years ago but I remember connecting a sender there on a 1998 7.4 MPI which seemed to work well.
Forum: General Q & A
04-28-2020, 09:19 AM
Replies: 12
Views: 3,074
Posted By AllDodge

Not that I'm aware of. There is a test port...

Not that I'm aware of. There is a test port (Shrader valve and cap) at item 6 in link. Might be able to attach sensor where the Shrader valve is
...
Forum: Donzi
02-08-2019, 11:32 AM
Replies: 7
Views: 3,666
Posted By Donzi1979

I can tell you I test drove a 26zx with a 454 mag...

I can tell you I test drove a 26zx with a 454 mag and it was dog, so I would imagine a 28zx would be worse ideal conditions maybe 60 mph. Also I remember hearing Donzi changed the 28 bottom to mimic...
Forum: Donzi
02-07-2019, 07:09 PM
Replies: 7
Views: 3,666
Posted By rak rua

You've probably found this stuff already but........

You've probably found this stuff already but.....
From the 2000 year owner's manual, I don't see the 28ZX single engine, the weight shown @ 6500lbs is the twin. Single obviously a bit lighter.

No...
10-02-2018, 01:23 PM
Replies: 7
Views: 3,604
Posted By TexomaPowerboater

They likely cost just as much as a 28 because...

They likely cost just as much as a 28 because they are a better fit for a typical budget boater's budget. It's light enough to pull comfortably with a 1/2 ton truck. Single engine is easier to work...
10-02-2018, 01:16 PM
Replies: 7
Views: 3,604
Posted By Donzi1979

In my opinion what you are seeing is limited...

In my opinion what you are seeing is limited supply, now 10 years ago the when markets started to go south there was a lot more of them available (along with other options as people disposed of...
Showing results 1 to 12 of 12


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.