Testing props
Posted in the prop section as well..
So factory labbed 28 Bravos I get the rpms Im after but not the mph. Factory labbed 30 Bravo is faster but not getting the rpm I need for peak HP. Like 400 tpms from where need to be.. Ideas? Which ones should I have dialed in for my boat. |
Have the 28’s cupped for more bite, might lower rpm a little but not nearly as much as the 30’s. |
Im leaning toward working the 30s more being they are faster than the 28s even thought the rpms are lower than I need. If I can get more rpms out of the 30s I should be good. Just dont think working the 28s will give me the speed . Already turning the 28s hard enough bit the mph isn't there.
|
Should be able to thin and sharpen the 30s for more rpm but keep the same pitch. In theory may result in more rpm and more speed
|
Kinda what I was thinking. That and cut the diffuser off
|
I'd be careful about cutting off the diffuser ring. Not that much to be gained and could make planing much harder.
|
Originally Posted by Griff
(Post 4650734)
I'd be careful about cutting off the diffuser ring. Not that much to be gained and could make planing much harder.
|
All times are GMT -5. The time now is 11:23 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.