Whats involved in a new floor?
 

This is original:

http://33outlaw.zenfolio.com/img/s12...24613083-3.jpg


This is after:


http://33outlaw.zenfolio.com/img/s5/...65723737-3.jpg

http://33outlaw.zenfolio.com/img/s12...70563260-3.jpg




This a big deal? the one estimate I`ve gotten is higher than the cost of the tanks...

Just buy some marine grade plywood, vinyl Ester resin and start measuring and fitting, cutting. I have only done a partial floor and it was easy. Good guy to ask is glassdave. He can give you advice, however its pretty straight forward. Save yourself a ton of $$ Dan!

Try posting this in the glass section too. Or just pm glassdave.

Not difficult but very smelly and messy.
Basic glass procedures apply.
Do a bunch of research, buy some materials and have at it.

The most important tip, when you are all done cold shower followed by hot. Trust me lol

Call Phil @ Upyours Powerboats ( Cigs are his specialty ).

its hard to tell from the pick, but do those tabs holding the tank in protrude up into where the floor would be??

Thats would be pretty retarded wouldnt it?

I have already explained in great detail on how to fix this. I'm done!!!! Did you get a price from Nabbers?

Get rid of the tabs as they do nothing except have potential to hit the floor and crack along the weld. Foam them in and don't forget to remove the Milwaukee saw. 700 who is Nabbers? 30 hr job total if your lucky

Captain Nabbers, does glass work for pier57