24' Outlaw 575sci Build
#51
Registered
Thread Starter
Got my electronic trim tab indicators wired up last night and wired in, sensors take a 12v source , and output a 5v signal to AEM 22 channel Can sensor module to CAN so it can be sent to my AEM cd7 Dash. Not to bad to configure and pretty neat once set up. I have two wires going to the front of the boat for all signals instead of one per signal.
#54
Registered
Beautiful build, very clean & done neatly. Just a question, the Hardin Marine exhaust flaps, are they spring loaded or do the rest closed naturally?
#55
Registered
Thread Starter
https://www.hardin-marine.com/p-8023...kit-gen-1.aspx
#56
Registered
Thread Starter
The following users liked this post:
TomZ (11-03-2021)
#59
Registered
Do you think that prop is going to be big enough for that engine? Or are you going for better holeshot? I know nothing of imco drives so that could have something to do with it. Just curious.
#60
Registered
Thread Starter
I think it will be a good starting point, The person running it before was running the prop with a slightly larger boat and ~800hp so I figured mine with ~750 on a smaller boat would match up, wont know until spring though. Wrapping up for the season and getting the boat ready for storage.